It depends on the gasket , a valve cover gasket would be less then an oil pan gasket ! Both valve cover gaskets $150- $ 190 , Intake manifold gasket $ 547 - $698 , Head gaskets $1,000 - $ 1,200 oil pan gasket $ 211 - $ 269 These are just estimates , not all repair shops charge the same . Here in Pennsylvanian local shops like pep boys charge $115.00 per hour , AAMCO does general repairs too , an they charge $ 95.00 per hour . I found the local Chevy dealer to be one of the cheapest around at $86.00 per hour ! It just depends on where you live ! you have to check around , Do let them bully you either , Ask what they charge to do you particular gasket an if they give you the run around tell them you'll try someplace else ! They always say well we will need to check it out first ! good luck hope this helps an may god bless you !!!!!!
SOURCE: what is the average cost for labor and parts to fix the exhaust?
It depends on the area your in as to how much labor and parts are being charged.
here in waco tx. a factory installed exhaust would be around 600 - 800 dollars,a aftermarket exhaust would be about half that.
Please dont forget to rate this solution
SOURCE: how to replace valve cover gasket 1998 chevy malibu
The first step is to remove all the parts that are in the way of you being able to remove the valve covers. (Ex.: air intake, loose wires etc.) Then you will need to remove your valve covers (using basic tools) and be very careful to not let anything get on your lifters, which your valve covers protect. Once you have the valve covers off compare the new gaskets to make sure they are the right size. Then remove the old gasket and replace with the new one using a high temp gasket sealant (available at any auto parts store) to attach the gasket to the valve covers. Then tighten down snug and check for leaks after replaced.
SOURCE: thermostat on a 2002 chevy malibu
Which engine>? There are a few different engines available.
SOURCE: 2006 chevy malibu.... where is the egr valve
If it's a US car then there is not an egr on the 2.2L engine. I think some of the mexican and oversea's engines had them, but not here in the US.
SOURCE: Chevy 2002 Malibu ERG valve
Symptoms of a bad EGR valve are usually stumbling idle or the engine stalling when the car is warm (normal operating temperature). Find the EGR valve and locate the vacuum line attached to it. Start the engine cold and wait for it to warm up. When the engine starts to stumble, pull off the vacuum line. If the EGR is bad, the engine idle will stabilize and no longer stumble.
184 views
Usually answered in minutes!
×