Question about 1991 Isuzu Rodeo

1 Answer

My 95 rodeo is loosing oil pressure then heats up and dies?

Posted by on

  • Ned C Cook
    Ned C Cook May 11, 2010

    Repeat? You lose press, then heats, then dies inthat order?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

There are a fw possibilities.

1. you have a cracked block and the oil is going in to the water system. To check this open the water cap ,When cold , and see if there is a milky substance in the water.

2. Look to see if there are any oily leaks around the valve pan areas.

3.Your oil pump may be failing.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Over heating have to keep putting water in my 95 rodeo


Have the cooling system pressure tested with a special tool to detect the source of the leak, if no leak is seen on the outside you most likely have a leaking head gasket. And no the oil may not be milky

Jul 06, 2017 | Cars & Trucks

1 Answer

95 taurus starts runs for 1-2 seconds then dies changed fuel filter 39 psi on fuel rail can make it run longer by cycling ign.switch from off to run really fast but leave it in run and dies after couple...


I would check the EEC relay, and the fuel pump relay too. But it sounds like the ignition module is loosing power, or the pump is not getting power after the engine starts.
The computer must see oil pressure or RPM to power the pump relay after the engine starts.

Sep 07, 2012 | 1995 Ford Taurus

1 Answer

What does repairing the freeze plug on a 95 Isuzu Rodeo entail?


ENGINE BLOWING FREEZE PLUG IS CAUSED BY RUST OR CORROSSION DUE TO TIME WEAR, HEAT STRESS, OR ENGINE GETTING TOO HOT PRESSURE BUILT UP DUE TO.ENGINE BLOCK CLOGGED NEED FLUSHING ALSO RADIATOR.REPLACE THERMOSTAT ALSO.

Jun 22, 2011 | 1995 Isuzu Rodeo

1 Answer

Low oil pressure light came on engine madee noise and died will not start but makes growling noise whe n trying to start


Sounds like you lost oil pressure and possibly the engine is shot due to losing pressure. It's possible the timing belt/chain broke. Even if this is this is the case, usually it requires valves replaced and head rebuilt/replaced.

Jun 13, 2011 | 2003 Isuzu Rodeo

1 Answer

95 isuzu rodeo is losing oil. No leaks and no blue smoke out tailpipe. Any ideas?


look for traces of oil in coolant, usually milky substance. Pull plugs and see if traces of oil or coolant are on plugs. Then do a cylinder leakage test to locate the vacuum leak.

Aug 16, 2010 | 1995 Isuzu Rodeo

1 Answer

95 rodeo wont start put it in drive then died


its have a bad idle too? verify sparks plugs, catalytic converter and the flow meter. Have a check engine light on?? Do an ecu scan

Jun 01, 2010 | 1995 Isuzu Rodeo

1 Answer

How much oil does a 1995 isuzu rodeo 3.2 hold


Your 95 isuzu rodeo with the 3.2 liter motor holds five quarts in the crankcase, plus your oil filter capacity, which is half of a quart.If you are changing your oil and filter, add a total of 5.5 quarts of new oil.Hope I could help!!!! Thanks!!

Apr 10, 2010 | 1995 Isuzu Rodeo

1 Answer

95 rodeo coolant problems


it could be leaking somewere else , get your cooling system pressure tested at a shop

Mar 07, 2009 | 1995 Isuzu Trooper

5 Answers

1995 isuzu Rodeo engine noise


valve guides worn and tappet adjustment required, can check tappet adjustment first to see slightly better before removing heads and getting valve guides repaired/replaced on heads common problem
if raise revs to 1500-2000rpm and hold does clatter come and go come and go (valve guides) if there all the time tappet clearance issue
if there only under load (1st rev up) for a couple of times then stops possible big end bearing
all these are common for this engine

Mar 06, 2009 | 1991 Isuzu Rodeo

Not finding what you are looking for?
1991 Isuzu Rodeo Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

82285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14438 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...