Question about 2009 Toyota Land Cruiser

1 Answer

Blinkers not working at all and the heater is

The blinkers stopped working and the heater is dead. All fuses seem to be ok.Also the engine light is on on the dash. I haven't noticed anything else not working.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 580 Answers

If both your hazard flashers and turn indicators are not working, replace your Flasher Module,
If turn indicators only are not working replace turn indicator switch
The heater is probably a seized blower motor if fan is out, if there is heat and no air flow. If no heat check thermostat.
Good Luck on your repairs. If there anymore I can do ask.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 jeep grand cherokee. Blinkers, heater and ac, high and low cooling fans....all quit working at once. checked fuses and relays under hood, inside fuse box good, repaced ignition switch, checked


checked means what, gandering at them
checking real is measuring them, with an OHM meter
fuse that look bad are in fact bad, but look ok can in fact have hair line cracks humans cant see, for sure old folks.
what works and what not is the TOP CLUE here,
1:heater blower dead, blower key word
2: ac DEAD sure it is with #1 PCM logic does that.
3:blinker something , dead, stuck on, one works 3 dont what?
4: high low cooling fans, underhood or dash?
5: does car drive, omg, does it? and not stated !!!!!
6: does car drive at night, headlamps work.
7: air bag on , driving? when? it will just key on, as do all warnings as s self test.
8: anything else work or not work , radio, wipers, and all things.?
9: does engine crank ,ok fast, sounds strong?
10: are head lamps dim.????
11: did you skip things that are dead in your report.?

ID bet you never scanned it , right.

what does GOOFED mean.???? sounds scary that.,!means hacking to me.... why say this.? with no photos show if damage. you cant fix modern cars lacking a scan tool.
I can do magic with my tools but you cant.
i have a full lab. (lab scopes and things you've never seen)
but a scan tool is dirt cheap and is a MUST.
IF the cars power distribution system fails
even a $10 voltmeter can find this, got one?

lets see. the list
1: fuses good, not the gandered at way.
2: battery lugs ok, not corroded.

tell more, get more, lots more,

Jan 23, 2017 | 2004 Jeep Grand Cherokee

1 Answer

2006 Hi there, my suzuki grand vitara harzard lamps have stopped working. all the fuses are ok some one said to check the relay ? can any one help


Q1: all 4 dead?
Q2: do blinkers work ? hummmm
alldata.com covers all this, log in and read>?
does car run perfectly
do all other lamps work? full bright head lights.
cranks fast not slow
battery charged? main car battery?
then
fuse meter good
fuse haz/turn good?
the tail fuse and tail relay most work or the HAZ switch is dead.
is the haz lamp dead? triangle ICON lamp?> in dash.

the schematic is below.
when you turn on the haz button , this sends 0v (ground) logic signal to the BCM puter.
and the turn /haz relay.
the blinker switch has its own inputs to the RELAY .
so one can fail and other work, and not stated, sadly.
its not really a relay its and electronics module.
(means testing it, is not relay like at all)
12v on both pins on left ? top.
in haz mode 0v on the yellow wire.?
if yes , yes, yes, then the relay is bad


25962146-cixb32bj0q4os0yupl5kc3qp-4-0.jpg
the 48 slot is haz/blink relay module.
25962146-cixb32bj0q4os0yupl5kc3qp-4-1.jpg

Nov 15, 2015 | 2006 Suzuki Grand Vitara

1 Answer

Turn signal & flashers stopped working on '95 geo tracker 2wd, 5 speed.


old post 95 tracker.
ALL four corners dead and dash (warn lamp dead) in cluster
do you hear i flash, click click????
first is fuses, but there are 2 .
http://www.fixkick.com/power-elect/95%20electrics/all-lamps95b.pdf


page 2 see that.
are the 2 blink/has fuses good. test good not just LOOK good
after all if a feed is shorted you will blow both. (tested)

the blinker module ,usually dont fail
its electronic and robust.
fuses good, then
the black wire ground cut or rusty a body
G200 it uses, and if bad usually kills the engine.
yellow-white must be 12vdc blinks on. key on
switch is bad. i bet this is ok
the relay green is OUTPUT
if the blinker has power it clicks
if it green wire flashes with test lamp the blinker module is good
if the output of the blinker switch is dead L and right
the switch is bad.
assumes both left and right sides not shorted. to ground.

Feb 16, 2014 | 1995 Geo Tracker

1 Answer

Cigarette liter stopped working then the next day the blower motor stopped working, Now the buzzer for head lites being left on stopped working and interval wipers stopped as well. This has been within a...


no power, means, what, cig lighter plug dead,?
try something else there, like a cell charger, still dead.?
if it is truely dead, the fuse is blown.
does head lights work, and engine run?
ok fuses that bad are bad, blown. (blown elements)
ok fuse that look GOOD, can in fact be bad, (tiny cracks.)
we never fail to test good looking fuses or go nuts for sure.
you can test fuse 3 ways.
1: DMM ohms, 0 ohms reading
2: voltmeter shows, 12v, on both sides of fuse, key on.
3: a fuse tester dealy bob at any autostore. (ill pass)
there are other ways, but are way too complex to type.
(ok a battery powered test light , yes, all auto stores sell them.
glow with a good fuse)
bingo?

Sep 03, 2013 | 1991 Honda Accord

1 Answer

Fuse controls dash lights


all or a few. ? there are warning lamps
and lamps that glow with head lamps on
are you saying really "all" are dead. every one.
if yes, blown fuse.
any thing else dead, engine, radio, dome light, brake, blinkers, etc?

Apr 22, 2013 | 2003 Suzuki Aerio

1 Answer

Hi my blinker is not working how can i repair that


Sometimes your blinker will stop working if a signal light bulb has burned out. Check your bulbs first. If all the bulbs are ok then check your fuse box for a blown fuse and lastly check the blinker itself in the fusebox. Your owners manual should show you where to find the fusebox and blinker.

Jun 08, 2011 | 2001 Hyundai Sonata

1 Answer

No left blinker/stop at 7pin connector


its actually located in the TIPM. more like a internal circuit breaker to protect the system. will have to have the TIPM reconfigured to vehicle spec with the dealer scan tool. problem is it doesnt always work because it shorts it out and/or you can only do it a couple of times berfore it has to be replaced

May 17, 2009 | 2006 Dodge Ram 3500 Truck

1 Answer

BLINKERS NOT WORKING


Ok this a way different problem than i thought it was first thing to look at is the relays and fuses and connectors to make sure they are not loose, pull them out and reconnect them. Engine running = vibration. Engine not running = no vibration. If thats good your left light blinker may be shorted to your constant power. Your right blinker may have an intermittent open. I looked at turn signal flashers online they are about $10 each, maybe swap em out then return if it does not fix it. It really sounds like a wiring problem though so look at the back side of where the light is connector and tell me what you find if anything
Good luck

Aug 14, 2008 | 1995 Pontiac Sunfire

1 Answer

Brake light/ blinker


Its one of your Relay switches.

Jul 04, 2008 | 2005 Ford Focus

Not finding what you are looking for?
2009 Toyota Land Cruiser Logo

229 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

81424 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...