Yes it does , it's inside the alternator . Part 1 GM CS144 Alternator Rebuilding Alternator Repair Visit www...
SOURCE: 1994 old cutlass ciera 3100 blown head gasket.
Get a Chilton's book on the car. It will take you thru the whole job, and give you the torque specs for putting it back together. You will need a torque wrench, foot pounds, and a good socket set.
SOURCE: 1994 Oldsmobile Cutlass Ciera V6-3100 3.1 L
Just follow the top rad hose to the engine.It will end up at the thermostat housing.The thermostat is under the thing the upper rad hose goes to and once you have drained down the radiator some then just unbolt it and put in ther new thermostat[with a new gasket of course after you scrapped all the old gasket off].
SOURCE: How do I change the spark plugs and wires on my
First you have to locate it. The spark plugs are located on the side of the engine heads and can be accessed through the wheel well. The no. 3 spark plug will be the hardest for you to get to, you need a spark plug socket with a built in swivel to loosen it and then remove it and install the new one by hand and the socket can only be used to loosen and tighten it.Vote for me if it helps
Testimonial: "Helped alot! I was told I was going to have to Rock the whole motor forward just to get to it! Thank you!"
SOURCE: transmission fluid fill 1994 oldsmobile cutlass
You can put fluid in running or not running but you must have it running to check fluid..
SOURCE: cant locate hazard flasher relay on my 1994 oldsmobile
ok i have found your answer but i found it on another website so i copied it for you to rummage thru I hope this is what u were seeking and glad to help.
flasher switch location
The flasher switch for the 94 cutlass is not where you would think it
would be it is behind and off to the side of the ashtray or below the
radio.
New Answer Headline
The above is accurate; getting to it is a little tricky. Open the
glove box and remove the tether wire connection at the door by
unscrewing the SHC screw with a T-15 Torx driver. This will expose 2 of
the 4 fuse panel mounting screws. Use an 8mm socket to remove all four
and wiggle the panel out. The flasher is behind and to the left in the
harness itself, not on a terminal block. Use a straight blade
screwdriver to gently pry the two prong connection from the unit (Mine
was an OEM Wagner - bright yellow.)
Additional Answer
It depends if you're talking about the turn signal flasher or
the emergency flasher. The emergency flasher is directly behind the
glovebox. If you're referring to the turn signal flasher, I just
replaced mine last night without having to mess with the fusebox or
glovebox. It turns out that it was attached by a clip on the right side
of the ashtray frame inside the dashboard. I took out the removable
"cup" part of the ashtray, then removed the two upper and two lower
ashtray frame screws. Next, I pulled the frame forward and disconnected
the small ashtray light. The power wire for the cigarette lighter can
stay attached. After I slide the frame out the rest of the way it was
easy to get to and replace the flasher unit.
139 views
Usually answered in minutes!
×