I have a mitsubishi mirage,a water leak has appear at the rear of the motor in a pipe that runs the lenght of the engine that has the heater hoses coming from it.is this an easy replacement,or does it need to go to the mechanic
An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: i have a mitsubishi mirage,a water has appear at
If you can see the leak and it is the hose it is an easy fix. If the leak can't be traced to the hose it is your heater core, which would need to go to a mechanic. If this has helped you, please leave me good feedback.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The water drip is quite normal, it is the moisture in the air that has frozen onto you evaporator coils and is now melting. It shows that your aircon is working. Look around shopping mall parking places, you will often see these little pools of water.
There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!
could the clear oil actually be water?. if it is leaking out in the area around or behind the passenger side front wheel on hot days, it is probably water from your A/C, system. it has an overflow or drainage pipe, as the process of cooling the air dehumidifies it and produces water. just a guess though