Question about 1993 Jeep Cherokee Country

1 Answer

1993 jeep cherokee 4.0L aw4 after swapping the transmission the transfer case will no longer shift out of 4low I even tried it at the pawl going into the case itself??

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Sounds like you have your transfer case on a bind i would take it back out and see what is holding it up from shifting

Posted on Jul 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where's the governor censor on my jeep grand Cherokee

In the transmission. Not hard to replace , but is very messy. Remove the transmission pan. The governor is on the passenger side. Three bolts to remove to replace the sensor.

Mar 22, 2015 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Where is the tcm located on a 1993 jeep grand Cherokee Laredo?

why ask this with not one of the 100 A/T issues with it?
TCC lockup failing? or will not shift to 2nd?
great question but no drive line options stated.
what country? yes they export jeeps.
what transmission , some have 3 choices got an A/T but which one?
AW4, 42RE or the 46RH (5.2l engine uses latter) that too , no engine stated. The RH has no TCM its got a governor. "hydromatic:"
all have a TCC but that is controlled by the PCM mostly

2wd or 4wd?

next time post the driveline in car.
and the symptom.
after all there can be 2 black boxes doing the shifting.

read the FSM

free info
if you even have one, see this page

Sep 30, 2014 | 1993 Jeep Grand Cherokee

1 Answer

I have a 94 jeep cheroke SE with the 4.0 and aw4 transmission with tps backfeed of 4.2 volts

have you tried starting in low and shift manually? aw4 transmission , is that all the time 4x4

Aug 13, 2017 | Jeep Cherokee Cars & Trucks

1 Answer

O99 jeep grand cherokee 4wd low does not work

This jeep is all wheeldrive and has a lever to go from 4high and 4low,first take a look at the transfer case linkage to make sure linkage is connected and not broken or frozen, alot of times the linkage freezes up from lack of use and sometimes bends or breaks so look at that first. if the linkage is good and no problem with it then we go on to the transfer case, take note that bent linkage will make it not go into 4low, okay the next step will need the transfer case to be checked for a inside bent fork or broken fork this will need to be done by a shop. the case needs to be removed and opened up to check the shift fork. good luck, hope this is helpful.johnjohn2_64.gif

Feb 13, 2011 | 1999 Jeep Grand Cherokee

1 Answer

Swapping the 4.0 engine out of a wrecked 1995

No the tab bracket is different for your transmission

May 22, 2010 | 1993 Jeep Grand Cherokee

1 Answer

I have a 1996 jeep grand cherokee laredo with transmission problems, what type of transmission is it if its an automatic ?

Trans could be an AW4 or a chrysler unit. AW4 pan is longer than it is wide chrysler one is nearly square with a corner cut off. Ones with a v8 usually have the chrysler trans.

Mar 07, 2010 | 1996 Jeep Grand Cherokee

1 Answer

42re>>aw4 swap

Far s I know it fits...make sure you have the correct torque converter for the unit you want to install. Only thing I'm not positive of is if the transfer case fits but pretty sure it does.Upi may need to change some linkage too. I have a AW4 in my 93 and I know there isn't a different engine configuration.

Jan 20, 2010 | 1993 Jeep Grand Cherokee

1 Answer

1993 Grand Cherokee AW4 transmission issue

have you tried a rolling shift? leave trans in drive and try moving 4x4 lever. it works on mine!

Mar 14, 2009 | 1993 Jeep Grand Cherokee

1 Answer

My jeep will not shift into 4low but 2wd and part time and 4high works fine then when you try to put it into 4 low its hard to pull up then when its their and you let offf the brake it just makes a loud...

Well, in the future it would be better to let us know what it is exactly that you drive, (cherokee, grand, jk, cj, ....)however, i'm guessing from the picture that you drive a grand. I dont know how long you have owned it or if you have put it in 4 low before, but you need to put the normal transmission in neutral before shifting to 4 low using the transfer case (the thing that gives you 4wheel drive via the lever) However, on your vehicle, if you have full time 4 wheel, i think you have the selec-trac transfer case and only have a switch. According to the Jeep website and i'm assuming your manual, you need to slow the vehicle to 2-3 miles per hour and then place it in neutral before attempting to shift to 4 low.

Jeep Site


Feb 18, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Cherokee Country Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides