Question about 2003 Mazda MPV

1 Answer

Key willnot come out oflock with power cut power key comes out

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 37 Answers

Just turn the steering wheel back and forth while pulling on the key, it will eventually come out.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I use my keys to unlock my car?


You should be able to use your key manually on either side of most cars.. or maybe your trunk even.

Mar 21, 2016 | Cars & Trucks

1 Answer

Engine willnot start


Try this,,,,relearn steps are crank it ,leave the key on 5 min,turn key off and repeat.
sometimes takes 2 or 3 times to relearn

Dec 23, 2012 | 2003 Cadillac Seville

1 Answer

At times my 2011 seinna willnot crank. the dash video will say that it does not recognise my key. then after a number of tries it will crank. my toyota dealer could find no problem.


Do you have any issues with your other key? There is a small RF transponder in your key that is transmitted to a module in your vehicle. When the module identifies a valid signal it will allow the vehicle to start. What happening is that your vehicle isn't identifying the key because the transponder signal is weak. I would speak to someone at the service department at the dealership where you purchased the vehicle and have them cut and program you a new key to replace your defective one.

May 27, 2011 | 2011 Toyota Sienna

1 Answer

My truck fuel pump willnot come on and i replaced it also the fuel pump relay switch it look,s the fuel pump fuse has no power help


"if this truck has a factory theft deterrent mode" it cuts off the signal to your pump. Take the battery cable off and let sit for 30 minutes, hook it back up now using a "new key" with the resistor pellet in it put it in to the start position, and wait ten minutes now turn off , now see if the doors can be locked and unlocked with the remote fob...close all doors and use remote fob to lock the doors. now using just the key unlock your drivers door. Now give it a shot and see if it will start. sorry but this is all i can come up with right now..what usually most people end up doing is to tow it to the dealer, and they have a special box with your code that resets the theft mode.

May 10, 2010 | 1994 Chevrolet Silverado 2500

1 Answer

When car is parked front windows come down automatacly and remote willnot work


you have a bad relay of fuse take 10 min pop the hood and look for an automatic window relay or if its a fuse you can wire in a switch to cut the power to the windows before you park.

Sep 24, 2009 | 2003 Nissan Altima

3 Answers

My 93 altima started yesterday just fine.Willnot even turn over today,there is power ,not even clicking. Checked fuses ,battery,moved relays around not sure how to check them


there is whats called a fuseable link on the + side of the battery taht may have burnt out over time!
bst get a auto electrician or a mechanic to come over & test it for you
Good luck Cheers Rob.

Jul 20, 2009 | 1993 Nissan Altima

1 Answer

4x4 1990 f150 will not start


Does the truck turn over but won’t start? If so there is a fusible link running from the starter solenoid behind the battery.
Also if you get nothing when you turn the key could be the solenoid. Its easy enough to jump the solenoid and check . Check all the fusible links coming off the power side of the solenoid and replace as needed.

bobby18rg@hotmail.com

Jul 11, 2009 | 1990 Ford F150

Not finding what you are looking for?
2003 Mazda MPV Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...