SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
SOURCE: Connector for Speed Sensor on1996 Honda Accord Auto Trans.
If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.
SOURCE: speed sensor codes return after replacing the sensor. are their more sensors
I would go to a parts store and ask for the to take a test to it(it is free) schucks does it. Or get it a diagnostics done on it but it would be a good idea.
I was told by more then one mechanic sensors go out, Yes even the brand new ones because what made you replace it the first time may be doing it again to the one you just did.
good luck.
Nikki2913
SOURCE: 1996 GMC Sierra Heater blower motor only works on
The blower motor resistor is located within a foot of the blower motor in the duct that the blower motor blows into. The resistor is actually cooled off by the blower motor blowing across it. It has a wire harness that connects it to motor & fan switch. It is held in place by 2-4 retaining screws. Disconnect wire harness,unscrew retaining screws then lift out. Reverse order to install.
119 views
Usually answered in minutes!
×