SOURCE: programing keyless entry
If you have an owners manual the programming instructions are in there. If no manual here they are:
1. Turn the ignition off.
2. Ground the receiver program terminal. Jump the two terminals located in the programing ground connector. (What this means in simple terms is locate the wires that run on the right side of the trunk. There is two black wires that has a plug on the end with two prongs. It is in between the antenna and tail lights.)
3. Within 2 seconds of connecting the prongs the door locks will lock. The unlock and the rear compartment lid release will produce a cycle, causing the horn to chirp. This indicates that the module is ready for reprogramming.
4. Press and hold the lock and unlock buttons at the same time until the doors lock and unlock. The rear compartment lid will release and the horn sounds to indicate that the transmitter has successfully been reprogrammed. (Hold buttons down for approximately 12 seconds)
5. Repeat the previous step for the remaining transmitters.
6. Remove the jumper at the program connector.
7. Verify the proper operation of each transmitter
SOURCE: 2004 chevy Malibu front struts
no but be carefull lots of pressure in those spring good luck pierre
SOURCE: program a keyless enrty remote start 2004 chevy malibu
Dealer only If you find a different means let me know
SOURCE: program a keyless entry remote on a 2000 chevy
PROGRAMMING
Method One
Sit in driver's seat
Close all doors
Press and HOLD UNLOCK button on door lock switch.
Insert and remove ignition key twice. Do NOT turn ignition switch
Insert ignition key a third time and leave it in the ignition switch. Do NOT turn ignition switch
Release door lock switch.
A chime will sound three times indicating remote programming active
Press and HOLD the LOCK and UNLOCK buttons on each remote for 5 seconds
A chime will sound twice for each remote: indicating successful programming
Remove the key from the ignition switch to exit programming
Method Two
Remotes can be programmed using diagnostic equipment.
SOURCE: program keyless entry for mazda rx8
its a dealership and computer job by them, you cant do it yourself
65 views
Usually answered in minutes!
Hi Anonymous, we want to help you with your question, but we need more information from you. Can you please add details in the comment box? Have you checked the car user manual sometimes it is explained in these manuals ?
×