Question about 1997 Ford Ranger SuperCab

1 Answer

How does gas lines disconnet from gas filter on ford ranger

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,486 Answers

Press the clips in at the side of the conections and pull.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1992 ford ranger 3.0 idle rough and the tail pipe is black and bad gas miles


check for clogged air filter and oxygen sensor if check eng light is on

Feb 28, 2015 | 1992 Ford Ranger

1 Answer

1998 Ford Ranger 4 cylinder will not start when cold, I put gas on the air cleaner and it starts. What is wrong


This is a problem caused by a defective fuel pressure check valve at the outlet of the electric fuel pump inside the gas tank. When this valve fails it allows gas to drain back to the tank from the filter and fuel lines, this creates a lean fuel condition and that can cause hard starting. There are reasons but this is the most common one.

Jan 20, 2012 | 2002 Ford Ranger Regular Cab

1 Answer

I just purchased a 1987 Ford Ranger 4X4 2.9 L and I have got to replace the gas tank. My question is (Does this truck have an in-line gas filter, if so where is it located, thanks


some of 87rangershave 2 fuel filters, one is a canister type located on the frame between the cab and the bed,the other is a inline and it is at the bottom of the firewall,under the truck, you can seeit by poping the hood,good luck

Sep 26, 2010 | 1987 Ford Ranger

1 Answer

How do i change fuel filter on 1987 ford ranger 2.9 liter


look under truck at drivers side door for the fuel lines. they will go into filter there and back out of filter there.you're looking for a round canister,you'll need to release the pressure by removing the gas acp also.there will be a plastic clip on both sides of the filter holding the fuel lines into the filter. pull those clips out with needle nose pliers, install the filter with the flow towards the front of motor, reinstall those clips unless new ones came with the new filter.keep in mind that you are under the truck looking up at filter, eye protection is a must!!!! hope this helps!!

Aug 23, 2010 | 1987 Ford Ranger

1 Answer

88 ranger has a new fuel pump new gas tank spark and plenty of spin but it wont crank where is the fuel filter located


IF IT IS THROTTLE BODY THEN FILTER IS IN THE FUEL LINE UNDER THE FLOOR AT DRIVERS FEET, IF ITS CARBURATED, THEN ITS THAT 1"'1-1/4 ROUND THINGY AT THE FUEL LINE WHERE IT GOES INTO CARB...

Feb 27, 2010 | 1988 Ford Ranger

1 Answer

Ford ranger suddenly lost power changed the fuel filter but that did not help.Engine picks up a little when manually primed on the fuel filter


Are in a cold climate, gas line freeze? Try puting gas line anti-freeze in the tank. Otherwise, it could be the fuel pump is going out. Check the fuel pressure or have it checked if don't have the proper tools to do it.

Dec 31, 2009 | 2004 Ford Ranger

1 Answer

Fuel filter installation on 1990 ford ranger xlt


It's on the driver side just behind the door. You need a special tool to pull the lines off of the existing filter. It seems to be a cheap simple tool. it slips over the line then you push toward the filter, it will click then you can pull the line off. Just pull the lines then replace with the new filter. The truck will start funny at first because it will be deprived of gas for a moment but then it should be fine.

HTH, Mike...

Dec 07, 2009 | 1990 Ford Ranger SuperCab

2 Answers

2002 ford ranger fuel pump..truck won't start after running out of gas


you probably sucked all of the dirt in your tank into the filter. try changing your filter. turn key on and have some listen by the gas tank for a humming sound to test the fuel pump and see if it is working.

Oct 06, 2009 | 2002 Ford Ranger Regular Cab

2 Answers

I cannot replace my fuel filter


You'll have to replace the gas line.

Jun 23, 2009 | 1984 Ford Ranger

1 Answer

Have a 86 ford ranger 2.3 l 4cy in mornings


its your fule filter theres 2 of them i the 86 ford ranger you need to change them the location of the fule filters are on google just tipe in fule filter 1986 ford ranger location it should pop up there about 8 dollors a peace easy fix and your truck is like new also get a new battey if you havent k have a good day. oh i know this because i own one had the same problem

Apr 02, 2009 | 1986 Ford Ranger 2WD

Not finding what you are looking for?
1997 Ford Ranger SuperCab Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...