SOURCE: 98 Saturn SL 1 sputters
Have a scanner hooked up to your car and do a data stream to see if your knock sensor is still working. On a heavy load, if the ECM detects detenation in the engine, it will automatically want to ****** the timing to make it run better on a load.
SOURCE: 04 Saturn stalling on take off and stops.
Pour the fuel injection cleaner to it....sounds like the injectors are dirty.....
SOURCE: Car stalls when you let off the gas when warm or idling
sounds like your IAC (idle air control valve) located on the throttle body towards the front of the engine held in by 2 torx screws. the iac controls the idle if the car when your not on the gas. i will post the steps to clean the iac and the passages that the iac goes into.
1. disconnect the iac connector
2. remove the iac
3 clean the iac pintle valve and check for wear
4. clean the passages that the pintle valve sits in (usually carbon build-up in there, you may need to remove the air intake tube and air filter box to get to the passages in the throttlebody)
5. if the iac looks ok and the passages are cleaned re-install and put everything back
6. start car and see if it idles like normal when warmed up. you may need to give it a few tries for the iac to re-learn its proper position so give it a few warmup cycles
7. if it still stalls check for proper operation of the iac via ohming out the connectors (if you look it up on google you will find the specs at which the iac is supposed to operate)
8. if the iac is working properly, check for vacuum leaks on the intake manifold and vacuum lines.
9. if no vacuum leaks are present and the iac id working properly after cleaning have a shop check the ecm (engine control module) for a bad circuit board, i've seen that haoppen as well
hope this helps!
SOURCE: engine running rough
It sounds like maybe yu have a fuel filter that getting plugged up.
To check this, see if you can remove it from the engine, then very carefully blow thru it in the direction the fuel travels, if clean you should be able to blow thru it easily, if not then replace.
The P132 is (E132) .................. Knock Sensor Circuitry Failure .... The knock sensor is what prevent engine ping from low octane. ...
It could also be you just got some bad gas.
You also might try topping off the tank with gas from another place and bring the octane level up if that is the problem.
Hope this helps
Good luck
81 views
Usually answered in minutes!
×