Question about 1989 Jeep Wrangler

1 Answer

1989 jeep wrangler-new coil,cap,rotor but still no spark

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem some years ago until I changed the crankshaft position sensor. Unless the start switch is faulty. Check both of those

Posted on Jul 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I got a1989 jeep wrangler its go a new coil and a new pick up in the distrubitor will still not get fire to plugs


Has the coil wire been replaced? Is the rotor turning in the distributor when the engine is cranked? I'm assuming you have a 2.5 L engine.

Jan 22, 2011 | 1989 Jeep Wrangler

1 Answer

No spark on 1989 jeep 6 banger / sahara /automatic. Power to the coil but no spark..Grrrrrr


Check under the cap to make sure rotor is in good condition and turning while cranking,Also clean rotor contacts inside cap.

Dec 03, 2009 | 1989 Jeep Wrangler

1 Answer

My 95jeep turns over but won't start ,no spark new coil,cap and rotor,picup censor


check to see if the points inside the rotor are gapped correctly, or if it has a electronic chip inside,then try replacing.

Sep 11, 2009 | 1995 Jeep Wrangler

1 Answer

No spark from ignition module on hot start


95 JEEP WRANGLER 4 CYL

No spark. I have changed out the distributor cap, rotor, wiring from coil to cap, and coil was replaced. I checked the distibutor by turning ignition key and observing the rotor turn. What else can I check. I did not observe a module.

Jun 19, 2009 | 1995 Jeep Wrangler

1 Answer

4 cyl. won't start,new plugs, wires,cap,etc.


a crank sensor tells the coil to fire.are you getting a signal at the coil to fire?

May 25, 2009 | 1995 Jeep Wrangler

1 Answer

1989 jeep wrangler has no spark


if this vehicle has a crank positoin sensor, i would suspect that first before anything else. it would be mounted transmission bell housing toward top. very common poroblem with jeeps. does it have fuel pressure?

Nov 11, 2008 | 1989 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...