SOURCE: how to change fuel filter 2000 excursion
Yes it is the tool for fuel lines and ac lines. Your local autoparts store should have them, they are universal. You need to use the small end for the fuel filter.
SOURCE: how to find my keypad # on a 2000 ford excursion
You are Welcome and Thanks for the Rating in advance.
SOURCE: 1988 460 motorhome starting problem
When its hooked up, you should be able to put 12 volts on the little stud on the solenoid and it should start. One large stud will have 12 volts on it, so just jump it right there. Did you get the wires in the right place. The solenoid should have 1 large wire going down to the starter. Be sure the battery cables are clean and tight ( both ends) Check battery voltage when cranking, should go to 10-11 volts. Check voltage between negative terminal on battery and engine, should be ZERO when cranking. The solenoid has 2 large studs, make sure the battery positive wire and all the other wires are hooked to this stud, the other large stud should just have the wire going to the starter.
SOURCE: ford 2000 excursion keyless entry not working
look online or go to the dealer and find a reprogramming procedure.
SOURCE: Fuel Filter replacement on Ford 2000 Excursion - V10
1.- For identify the right fuse, check your 2000-Ford-Excursion-Owners-Manual position 112, 20AMP (Maxi Fuse); details in the page 138 and next.
2.- Ford Excursion, Expedition, Lincoln Navigator
2000-2005, Fuel Filter - Removal & Installation
NOTE
A fuel line disconnect tool is needed for this procedure.
CAUTION
Fuel injection systems remain under pressure, even after the
engine has been turned OFF. The fuel system pressure must be relieved
before disconnecting any fuel lines. Failure to do so may result in fire
and/or personal injury.
Negative battery cable
Fuel lines from the fuel filter. Have a drain pan handy to catch
any residual fuel once the lines are separated.
Safety clip from the male hose
Install and push the fuel line disconnect tool into the female
fitting.
NOTE
Inspect the fuel lines for any damage after the fuel is finished
draining.
Male and female fittings from the filter
Fuel filter from the bracket and the retainer, if equipped. Note
the direction of the flow arrow so the replacement filter can be
installed correctly.
Fig. Typical fuel filter mounting along an under-vehicle frame
rail
To install:
Fuel filter into the mounting bracket with the flow arrow pointing
in the correct direction
Fuel lines to the fuel filter. Align and push the male tube into
the female fitting until a click is heard. Pull on the fitting to ensure
that it is fully engaged, then install the safety clip.
NOTE
When the battery has been disconnected and reconnected, some
abnormal drive symptoms may occur while the Powertrain Control Module
(PCM) relearns its adaptive strategy. The vehicle may need to be driven
10 miles (16 km) or more to relearn the strategy.
Hope this helped.
135 views
Usually answered in minutes!
×