Question about 2002 GMC Denali

1 Answer

Where is fuel pressure regulator- 2002 denali

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

Its located on the fuel rail. on the right or left side of the engine.

Posted on Jul 11, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 314 Answers

SOURCE: 2002 chevy Blazer hard starting

This sounds like the fuel pump is shot. The pump has a 'dead' spot and when the engine is started by using 'nasty' starting fluid it will go to the running mode and run fine. Never use starting fluid!!! A bit of gas is best, just use common sence. Frankster016

Posted on Nov 26, 2008

  • 5 Answers

SOURCE: Where is the fuel pressure regulator located on an 2002 f150 v6?

in the center of the motor,in the rear on the fuel rail

Posted on Jan 19, 2009

blueextc3221
  • 15935 Answers

SOURCE: Where is the fuel pressure regulator on a 2002

This is one of the best manufacturer support sites!!
HYUNDAI SUPPORT
This includes diagrams, repair manual, tech reports etc.
A free registartion is all that is required.

Pressure regulators are usually mounted at the end of the fuel rail.
Yours is on the delivery pipe with the fuel injectors.
Be careful not to drop the injectors when removing the delivery pipe. 7c3c507.gif Thanks for using FixYa - a FixYa rating is appreciated!!

Posted on Feb 17, 2009

  • 92 Answers

SOURCE: fuel pressure regulator had no vacuum line connected

another engineers wet dream. think of it this way . what is normally in the intake when the engine is running.. answer vacume, hence the regulator gets its vacume without a hose connected to it as its already in a full time vacume chamber.no hose required . ps be carefull to seat the regulator and o rings securely into the housing befor you reattach the secureing metal clip.
good luck chris

Posted on Mar 23, 2009

  • 1 Answer

SOURCE: toomuch fuel pressure. fuel regulator replaced

how do you know it has too much fuel pressure? what is your car doing?

Posted on Jun 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is location of fuel volume regulator


Fuel pressure regulator ! An it's location is inside the fuel tank .
The fuel pump (FP) module contains the fuel pump, fuel pressure regulator and the fuel sender assembly. The fuel pressure regulator is attached to the fuel pump in the fuel pump module located in the fuel tank. It regulates fuel pressure supplied to the fuel injectors. The fuel pressure regulator is a diaphragm-operated relief valve. Fuel pressure is established by a spring preload applied to the diaphragm. Excess fuel is bypassed through the regulator and returned to the fuel tank.

Nov 18, 2015 | 2002 Ford Explorer

1 Answer

How do you know if your air &gas regulator on honda accord 2002 ex is working ?????


If you mean the fuel pressure regulator, you do a fuel pressure test. That checks the fuel pump, fuel filter, and the pressure regulator. Rent or borrow a fuel pressure gauge, hook it onto the test port, turn key on, and read the pressure. With engine running, read it again, it may drop a few psi which is normal. Here is a how to: http://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator

May 13, 2015 | 2002 Honda Accord

1 Answer

2004 gmc yukon denali fuel pressure regulator where is it located


There is not a fuel pressure regulator unfortunately. It is all inclusive in the fuel pump. I looked personally in all locations. I removed the upper intake assembly and it was not there i also dropped the gas tank. AC Delco is the fuel pump to use. I have heard from others that the generic models dont last.

Oct 09, 2011 | Cars & Trucks

1 Answer

How to replace Fuel Injection Pressure Regulator on 2002 chrysler sebring


Fuel Pressure Regulator Removal & Installation To Remove:
  1. Spread tangs on pressure regulator retainer.
  2. Pry fuel pressure regulator out of housing.
  3. Ensure both upper and lower O-rings were removed with regulator.
To Install:
  1. Lightly lubricate the O-rings with clean engine oil and place them into opening in pump module.
  2. Push regulator into opening in pump module.
  3. Tabs hold regulator in housing.
prev.gif next.gif

Feb 12, 2011 | 2002 Chrysler Sebring

1 Answer

2002 sebring where is the fuel pressure regulator located?


The fuel system is under a constant pressure, even with engine off. before servicing the fuel filter/fuel pressure regulator, the fuel system pressure must be released.
CAUTION The fuel system is under pressure when the engine is running, 58 psi, plus or minus 5 psi. (400 kPa plus or minus 34 kPa). The fuel pump module contains a check valve to maintain some fuel pressure even when the engine is not operating. This will help to start the engine. Before servicing the fuel filter/fuel pressure regulator, the fuel system pressure must be released.

Hope this help.

Apr 02, 2010 | 2002 Chrysler Sebring

1 Answer

Vehicle chokes, sputters, and then shuts off


Start with the simple and replace the fuel filter. The fuel filter may have reached the end of it's life time and is dirty causing the issues you have. The worst is the fuel pump it self has gone bad and needs to be replaced, the fuel pump should be producing 62 to 65 PSI when the engine is started and should drop no more then 5 PSI when the engine is running. You can check the fuel pressure at the shredder valve with a fuel pressure gauge. Good luck and keep me posted, be glad to help get your Yukon running 100% again.

Nov 16, 2009 | 2002 GMC Denali

2 Answers

Yukon Denali Fuel Trim bank One and Two running too lean?


Could also be fuel filter, pressure, vacuum leak, etc. Check these two articles out, they should help too - http://www.obd-codes.com/p0171 and http://www.obd-codes.com/p0174

Dec 21, 2008 | 2002 GMC Yukon Denali

1 Answer

2005 GMC Denali


THIS COULD BE SEVERAL DIFFERENT PROBLEMS. SOUNDS AS IF IT MAY BE A FUEL DELIVERY CONCERN. THE ONLY WAY TO DIAG. THIS CONCERN WOULD BE USING AN UPDATED SCANNER FOR THIS VEHICLE. THE "SVC BRAKE SYSTEM" IS MOST LIKLEY CAUSED FROM THE NO START ENG CONCERN. IF I WERE TO TO TAKE AN EASY GUESS, YOU CAN CHECK YOUR FUEL PRESSURE REGULATOR, IT MAY BE LEAKING. TURN KEY TO RUN, DISCONNECT VACCUME HOSE @ REGULATOR. SEE IF FUEL IS COMING FROM REGULATOR, IF THERE IS, YOUR REGULATOR IS FAULTY. YOU MAY ALSO HAVE A DEFECTIVE FUEL PUMP, BUT A GUAGE IS NEEDED TO VERIFY.

Nov 08, 2008 | 2002 GMC Yukon Denali

2 Answers

There isn't any fuel getting to my truck and it won't start


No fuel pressure indicates one of three problems. Fuse in fuse box, relay in relay box under the hood or fuel pump located in fuel tank.

Jul 26, 2008 | 2002 GMC Yukon Denali

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

266 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...