Question about 2002 Jeep Grand Cherokee

1 Answer

Thermastate and high heat

I replaced the top Thermastate by my jeep Grand Charokee still gets high heat when the car is not moving. I can hear the radiator bubble. Last week the top hose going into the engine block burst, which I replaced along with the top thermastate. My friend thinks I put it in backword, but the same thing was happening before I replaced it.
Any thoughts.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 38 Answers

Yes i would check if your radiator fin turns on when the engine gets warm.
Most likely thats the cause.

Posted on Jul 11, 2009

  • Alie Jul 11, 2009

    Or your water pomp could be defect.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you conver front axel u joint type to a cv joint type on an 95 jeep grand charokee lorado


I owned a 93 GC 4x4 and I did replace my front axles with CV joint axles. The new axles came with CV joints, with a rubber boot and all so yes you can.

Sep 09, 2012 | 1995 Jeep Grand Cherokee

1 Answer

My 96 Grand Charokee sat for 3 years. I can't get it to start.


What about the fuel, was it drained and the system flushed. Gas turns to goop after this long and will barely burn.

Apr 13, 2012 | 1996 Jeep Grand Cherokee

1 Answer

I have a 1999 jeep grand charokee and my power window dont work no fues or relay .....


There's a small motor inside that is probably shot. Of course the switches have a tendency to stop working if treated harshly. If you hear the motor run but no movement, its an armature broken or even a missing pin. You'll want to check armature anyway since if stuck it'll burn a motor easily.

Feb 06, 2012 | 1999 Jeep Grand Cherokee

1 Answer

I need to know where the voltage regulator is located at on my 93 jeep grand charokee


Hi, your regulator is integrated into the alternator. Please let me know if you have more questions, and thanks for using FixYa.

jturcotte_1142.gif

Mar 01, 2011 | 1993 Jeep Grand Cherokee

2 Answers

95 jeep grand charokee laredo hard to start,


Check your spark plug, wires, distributor cap and finger. If you spark plugs older than 15000ml, replace them. To check your spark plug wires, use a tester (U can buy at any auto store) you hold direct on the wire and a small sparkling will show you if the wire works or not. You can check the wires also with this: use a single spark plug (don't remove one out your engine!), remove the wire from first SP, connect it with the single SP, hold it to ground, let someone start your engine...you need to see regular sparks.. do this step by step with all 6 wires. If all wires are fine, check the SP's, If you miss on one wire, replace the wire, if you miss on more than one, chekc the distributor cap and finger. If this items are older than 20000ml or 5 years, replace them.

Oct 27, 2009 | 1995 Jeep Grand Cherokee

1 Answer

How do you remove/replace wiper switch on 1995 jeep grand charokee


Disconnect and Isolate Negative Barrety cable. Remove screw in bottom of steering column shroud cover. ( bottom side of steering column between wiper switch and turn signal switch) Unsnap shroud halves and remove from column. Disconnect wireing harness connector from multi function switch. Remove 2 screws securing switch to mounting housing. Install in reverse order.

Oct 25, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Only have luke warm heat from heater changed thermastate did not help what else could it be


The Blend door in the HVAC box. Unfortunatly this is the main cause of this type of problem u have to remove the dash and replace the blend door and the acuator.

Oct 13, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Spark plug gap for 2004 jeep grand charokee for Bosch Platinum + spark plugs?


The spark plug gap should be posted on the emissions sticker under the hood. The gap setting posted on the sticker is good for all brands and types of plugs for your vehicule

Oct 01, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Brake lights


their is a panel in the interior qtr panel and may have 2 screws inside at latch take the screws out and check inside of qtr and lightly hit the outside of lamp while trying to pull it out.

Jan 24, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Heater fan problem


its on the passenger side firewall under the hood you cant miss it its the only thing with a otor there...

Jan 21, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...