Hello,
can you catch the check engine light while its on and scan for the codes? If you can get the code(s) i should be able to tell you exactly what the problem is. Do you notice if the vehicle heats up or does the coolant light just flash after 30-60 mins? It could possibly be your water pump failing or the belt that runs it. I would check that along with the codes. Please advise
There no code ......code that pop was egr
And the temperature gauge inside the car never overheats all cooling fans turn on....
If the car doesn't actually overheat it could be the thermostat or something in that area. Could be a vacuum leak but its odd how it would run for 30-60 mins. I would double check the thermostat and the surrounding hoses, make sure everything looks good
Its run for bout 20 30 minutes then coolant temperature light flashes and car shuts off.... Then I gottat drive it very slow
×
SOURCE: cylinder 4 misfire on a 2000 crown victoria interceptor
first cylinder 4 is the last on the passenger side . first pull the coil out and check if there is water where the plug is. if there is take the water out and dry up the coil. if you find water you got a crack manifold or a bad intake manifold gasket. if there is no water replace the coil. good luck
SOURCE: my check engine light came on and my fluid levels
Could be many different things. Take it to a dealership or autozone and have them hook it up to their hand held computer. They will be able to tell you exactly what is wrong. A lot easier then just guessing.
SOURCE: car wont start no fuel
It is located in the trunk, left hand side. There should be a small hole in carpet, look for a red button and push it. Hope this helps.
83 views
Usually answered in minutes!
×