Question about 2006 Fiat 124

1 Answer

I have a 1974 buick Apollo with a 2 barrel carb stalling problem

I have a 1974 buick Apollo with 350v8 and a rebuilt rochester 2 jet carb. After the car is warmed up when you put it in gear the car just stalls and dies. When its cold there is not a problem. It restarts okay, but just continues to stall when you put it in gear.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

Sounds like the idle screw on the linkage is not set correctly.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a rochester 2 barrel carb on a 1963 Buick 198 with #7023049 031 5 2 stamped on the body. Is there a rebuilt available?


Try the website below. They have a ph# on the Home page. I might call before I order just to make sure. Shows the kit as $28


7023049 Carburetor Info Page

Sep 18, 2017 | Buick Cars & Trucks

1 Answer

Need vaccum diagram for chevy impala 1978 with 6 in line motor with 1 barrel carb. rochester mono jet


To the intake manifold , from your choke, choke close incoming air is restricted, adjustment of the choke via thermostatic spring coil or electric heating element, loosen the 3 screws , as spring heats up the choke gradually opens, hope this helps

Dec 31, 2016 | Cars & Trucks

1 Answer

I have a 2007 Merc 90hp 4 stroke EFI. Stalls when trying to start, have to restart several times, most of the time even when warm it stalls when I put in nutral


You have dirty or clogged fuel jets. Most likely the low speed pilot jets. You will have to remove and take apart the carbs to clean the jets.

Oct 28, 2016 | Cars & Trucks

1 Answer

Missing terribly but runs. When put in gear it shuts off. What's wrong?


Buick LeSabre Questions - Running without a Mass Air Flow ...

www.cargurus.com > Questions > Buick > LeSabre
CarGurusJun 11, 2013 - It drives perfect then all of a sudden while im driving it stallsoccasionally. ... it idles ruff an stalls until it warms up does the same in gear its throwing engine ... If you are installing a idle air control valve in a 1990 Buick Centuryyou ... I put in my 3rd MAF sensor in 2 weeks and now the car is no longer stalling.

Sep 29, 2015 | 1990 Buick LeSabre

1 Answer

What could be wrong with the cabbrator on a 1988 Chevy silverado


It's a rochester carb most likely, and any number of things could be wrong.
Most common issue is clogged jets/needles or a sticking float in the bowl or choke issues.
You can fine rebuilt units on jegs.com or summitracing.com
Price is decent and I believe they have a warranty too.

Mar 15, 2014 | Cars & Trucks

1 Answer

How do you set the idle


There are all kinds of adjustments on that vehicle. Also, it depends on which carburetor it is equipped with. That vehicle came with a Rochester 2-barrel carb, a Rochester Quadrajet carb, or a Holley 4- barrel carb. There is not enough time or space to post all of the information about this here. I would recommend going to alldatadiy.com and subscribing to the service information for your vehicle for a small annual fee, or purchacing a manual like Chilton or Haynes.

May 18, 2012 | 1987 Chrysler Fifth Avenue

2 Answers

89 cadi chokes/floods itself out


have an accredited service shop do a carby check as it could be a float level to high, incorrect mixture adjustment or power valve /pump incorrectly fitted
black smoke is excessive fuel and a rebuilt carby, if done by a DIY, is always suspect

Nov 28, 2017 | 1989 Cadillac Brougham

1 Answer

My 1986 GMC Vandura With a 305 and rochester Q Jet Idles Rich and after it warms up looses power and floods out stalling where ever it feels like. Please Help,


Possibly a hole in the float . ( carburator) You'll have to take the carb apart and remove the float. Shake it and see if there is gas in it. If it's not a brass float, you may just need to adjust it, and clean the carb.

Dec 17, 2010 | 1984 GMC VanDura

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fiat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Marvin
Marvin

Level 3 Expert

83850 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a Fiat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...