Crank Sensor for 2003 Chevrolet Silverado 1500hd

SOURCE: 1997 Chevrolet Silverado Fuel System

Hello Johnholley
I am wondering do you hear the fuel pump when you just turn the key into the on run position not crank just in run and listen and see if you hear the fuel pump run for a second, If you don't hear it you will want to check for power at the fuel tank, and have some one cycle the key while your under the truck with a test light. Hopefully you have power and you hear the fuel pump run. Now if you do hear the fuel pump running then the next thing you will want to check is for spark, It could be the ignition module or pickup coil. check out those thing and I am sure you will be able to figure out whats going on. If you don't get back to me and we can try a few other methods. I sure hope that helps you out johnholley. and thanks for using Fix Ya Bear001

SOURCE: change oil light

Hi...
Are 2 step to RESET the engine oil on your chevy 02.

The first one ..
Turn the key to RUN position. Engine OFF.
Them FULLY PRESS and REALESE the ACCELERATOR PEDAL
For 3 times between 5 seconds and wait until the Change OIL start blinking and goes OFF.

Now the System is reset.

The second step is.

2-- This procedure need the RADIO, if you have an aftermarket
Radio you don't be able to do.
Turn the ignition switch to ON position,
turn OFF the RADIO,
Press and hold the Tune disp, button for 5 seconds or until
Settings is displayed,
Press the seek ptype or seek pscan up and dow to scroll the main menu,
Scroll until the OIL LIFE appear on display
Press the 1prev or 2next to scroll the sub menu, RESET will be displayed , Press the TUNE disp buttom to reset,
A chime will be heard to verify the new settings and done
Will be displayed for one second.
Press the TUNE DISP to exit from the program,
A chime will be heard to verify the exit.

I hope this help on your question.
Thank you for use fixya...

SOURCE: bad sensor on chevy truck

There are 2 both located in the block..

SOURCE: 2003 chevy silverado 1500HD LT. A/C fan works intermittently

First check fuses, then test blower motor, Last Temp control switch

SOURCE: 2005 Chevrolet Silverado 1500HD 6.0 motor. I am

Coil "D" should be Cylinder #4
Coil "A" = Cylinder #1
Coil "B" = Cylinder #2
Coil "C" = Cylinder #3.
Coil "D" = Cylinder #4
Coil "E" = Cylinder #5
Coil "F" = Cylinder #6
Coil "G" = Cylinder #7
Coil "H" = Cylinder #8

Firing Order for 6.0L
1-8-7-2-6-5-4-3
Cylinders:
(back of vehicle)
8----------7
6----------5
4----------3
2----------1
Ignition Coils are adjacent to the corresponding Cylinder

Let me know if this helped.

Testimonial: "Very quick response and very knowledgeable. Thanks,"