Manual odometer
SOURCE: Hi, I installed a new engine in my 1997 Toyota
basically no it's not... well not legally. look up odometer tampering in your state/province country
http://www.bmv.ohio.gov/misc/odom_tamp.htm
this is one example from ohio
Robert
SOURCE: Hi,I fitted a brand new motor in my car and would
Did you already take a look by the plastic in front of the meters if there is or are screws? There should be some way to take that part of the dash of. then with some tweezers, after removing the plastic, you can carefully turn the dials. to your desired number.btw, turn them with the clock, not against the clock.
hope you'll find the screws and get it open.
greetings........Gilbert.
SOURCE: How to reset timing belt light
to reset the light you need to remove speedo dash assembly ,on the back of the printed curcuit there is a small screw and a hole next to it remove screw and fit to empty hole . refit assembly
SOURCE: Timing belt light of Toyota LandCruiser 2006
the reset procedure of the timing belt light is all done by pressing the trip meter button and holding it in whilst the ignition is turned to on then select from the trip button then continue pressing until you come to 15 on trip metre, turn off and then restart. The light should then go off.
SOURCE: my timing belt light comes and i need to reset the
You need to remove the dash first, then remove the speedo /guage cluster unit from the vehicle, by undoing the 3 or 4 plugs on the back of the cluster unit. when you look at the back of the unit you will see alot of srews and wires. look closely around the middle part and you will notice a small phillips screw with a empty hole next to it. remove the srew and put it back into the empty hole which was next to it. This resets the timing belt lamp. good luck
566 views
Usually answered in minutes!
×