Question about 1988 Honda Accord 4 Door

1 Answer

Everytime i engage brake and clutch to stop my car stalls what could this be

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 84 Answers

Soldering cracks in your main relay.

Posted on Jul 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Online chat


If you have the foot on the brake when stopping and it stalls , try slowing down and stopping on the hand brake to see if the engine stalls . If it doesn't stall on the hand brake then I would suspect a leak in the brake booster that is affecting the engine by letting air into the manifold through the activated booster. If there is no difference have the fault codes read as there may be a missing/ faulty vacuum line connected to a actuator in the gear box.

Mar 10, 2014 | Nissan Cars & Trucks

2 Answers

My car stalls when brake and stop


your idle valve may need cleaning. do you get ruff idling on startup ???

Jul 20, 2013 | Vauxhall Cars & Trucks

1 Answer

My wife has a Peugot 307 petrol engine. When pulling off from cold, there is a grinding / grating noise. It only occurs when the car is moving and lasts 1 to 2 minutes. Dip the clutch and the noise...


Sticking clutch throw-out bearing arm or linkage/cable, or pedal, so that throw-out bearing is just barely and intermittently touching the throw-out plate of the clutch. Depressing the pedal slightly engages the bearing to the plate causing positive drive of the bearing, quieting the noise. After running a while, the bearing moves sufficient distance to disengage. Next time it happens, with the vehicle stopped, in neutral and with the parking brake set, stick your toes under the clutch pedal and pull it back, see if the noise stops or changes..

Sep 07, 2017 | Peugeot 307 Cars & Trucks

1 Answer

When weather is hot outside after car runs awhile it stops pulling,idle's fine,continues to run but won't pull when clutch is engaged ?


check hand brake tension , sounds like it is grabbing after heating up, or is the clutch on its way out simple test for clutch , hop in car apply hand brake and foot brake place car in reverse let clutch out slowly ,if car stalls clutch is good if car stays running clutch failure, replace clutch
warning read and do it properly hand brake and foot brake on at all times during test,make sure car is in a well open area, hope this helps

Jun 12, 2010 | 1992 Toyota Celica

2 Answers

Saab 900 manual (1991) - difficult to get into 1st gear/reverse. Sometimes won't go into gear while engine is on. Very easy to stall - clutch control very difficult. In reverse it just stalls when I let...


clutch hydraulic system has failed
low fluid levels , air in system,problem clutch master cylinder will cause the indicated problems
take it to a clutch/brake specialist shop and get a proper diagnosis and quote

Nov 28, 2017 | 1991 Saab 900

2 Answers

Engine sputters when clutch/brake engaged; revs when brake only engaged


check under dash where pedals are as there may be wiring there that the pedals are touching and shorting out

Jun 02, 2009 | 1998 Jeep Wrangler

1 Answer

Car stalling after turns on, dies while driving


First of all you should check your transimision fluid in your gearbox, if the car is automatic, and refill until the proper sign.
Utherwise you should check the clutch if it works properly, maybe you have to adjust the clutches gap.

Jan 28, 2009 | 1987 Ford Bronco II

1 Answer

Overdrive and stalling out


it sounds like your torqe convertor lock up switch is faulty garage fix

Sep 06, 2008 | 2001 Dodge Durango

1 Answer

Clutch won't engage and back wheels locked


sound like back brakes locked up burn up your clutch.

Jul 28, 2008 | 1996 Ford Aspire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

81424 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...