Question about 2001 Mercedes-Benz CLK-Class

1 Answer

When i tried to change the air flow meter with a new one my car doesnt work properly . did i need a reset for the computer ? or what it call a rehabilitation for the new pieces ?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

You need to clear error by STAR .

or if you love to try, unplug earth battery ,
wait for a minute then reconnect.

then try new MAF again.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Have a n16 pulsar will not idle when it gets to running temperature can the idle be adjusted


no they cant, could be an air leak after the airflow meter, could be a faulty air flow meter or faulty idle motor. with nissans computer can carry out an "idle volume learn" that will reset the idle motor. or even check the basics, oil level and spark plug condition

Mar 07, 2014 | Nissan Cars & Trucks

1 Answer

Audi a4 tdi 2002 smoke and idle problem


The battery in a 2002 Audi A4 is located at the rear of the engine compartment (back near the windshield) & has a tie down requiring a 6mm Allen wrench to remove it.----------------------------------------------------------------------------------------
auto HID Xenon light

Jan 15, 2013 | Cars & Trucks

1 Answer

Buick 3800 wont start help


Change plugs check wires for correct connection. Check pcv for vacuumn leaks. Starter fluid on mass air flow meter may damage it.

Sep 30, 2009 | 1998 Buick LeSabre

1 Answer

Air flow meter


air flow meters are expensive i would first replace the coolant temperature sensor

May 28, 2009 | 1996 BMW 318

2 Answers

Idle and Power Where is the fuel filter?


Fuel filter is inside the gas tank and its built into the fuel pump housing. You need to remove the back seat and get into the tank via access hole under the seat. Than you need to "split" the fuel pump assembly open and get the filter out. Reverse procedure to assemble. Those filters are rated for 105k miles. My 00 Maxima has 167K on it and it runs just fine with the original. As far as the air flow meter , its a pretty common part that fails and that's why 00 Max air flow meter costs only $100 and all others $500 or more. If you replace an air flow meter, make sure that you use a "NISSAN" air filter or YOU WILL BE replacing the air flow meter AGAIN. Also with the new air flow meter the cars ECM/Computer needs to be reprogrammed. As far as plenum gaskets leaking?? unless someone had it apart and didnt put it back together the right way, its "VERY UNLIKELY" for those gaskets to be bad. Totally bullet proof.

Mar 03, 2009 | 2000 Nissan Maxima

1 Answer

Is a airflow meter for v6 1993 camry needed? I am trying to put an cold air intake, but im not sure if i can remove the airflow meter or not. also any help on intalling a cold air intake on the car would...


You MUST have the air flow meter installed on your vehicle. The car will not run if you remove it. The Air Flow Meter measures the amount of air coming into the engine, and also the air temperature. This information is sent to the fuel injection computer, to determine the proper fuel to be injected. In reality, cars with "air-flow meters" do not really "benefit" from a cold air intake, due to the inherent restriction that the air flow meter causes, as it measures the air.
In short, I would not install the intake, you won't see much benefit. The graciousness of a FixYa rating for my assistance would be greatly appreciated..

Jan 14, 2009 | 1993 Toyota Camry V6

1 Answer

Regulator problems


clean the air filter and oxygen sensor located in the duct leading to the air filter. buy a can of mass air flow sensor cleaner from autozone. if that doesnt work then completely replace the mass air flow sensor , if that still doesnt work try replacing the oxygen sensor. also try putting seafoam. in your gas tank from autozone itll clean out your injectors.and if your still having problems stalling and not restarting then it could be your timing belt and you might need a whole new engine, i had to put a whole new engine in mine becuase the timing was off.

Jul 28, 2008 | 1995 Nissan Maxima

2 Answers

Bmw 316 e36


change your fuel filter if it does'nt work check that your fuel pressure is ok if not check that all the plugs on your air intake is all good and pluged in properly

Jul 16, 2008 | 1997 BMW 318

Not finding what you are looking for?
2001 Mercedes-Benz CLK-Class Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Marvin
Marvin

Level 3 Expert

81294 Answers

Joseph Prosser

Level 3 Expert

772 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...