Blower motor will not blow out of vents 2008 ford ranger

sounds like blower switch

Not giving you a "continous blowing" would indicate that you have an electrical problem. More than likely that problem is within the blower motor itself. Possibly the motor windings are overheating and shutting down the motor. Then after the wires cools down enough, it starts again. I would say replace the blower motor.

unplug the blower motor connector 2 wires and put a test lit across if lits replace the blower motor

Sounds like there is an electrical problem. Its probably in the ac / heat system. I would suspect the blower motor resistor or blower motor is going bad.

if your heater dosent blow through the vents at all you have a bad blower motor usually located on the fire wall of most vehicles

the heater vacuum motor and lines needs to be checked.Also get the blend door checked.

NO HEAT ON FLOOR VENTS

---------

As per your problem mentioned. There are few solved help links to troubleshoot these problems. Go through the list and Click the link below:----

2000 Toyota Avalon: No heat on Passenger Side?

http://whatisbyme.blogspot.in/2012/05/2000-toyota-avalon-no-heat-on-passenger.html

------------

No heat on Oldsmobile Silhouette?

http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html

------------

Heater blows cold?

http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html

-----------

Heat blows cold on drivers side and hot on passenger side?

http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html

----------

Hot air on the driver's side vents only?

http://repairhelpcenter.blogspot.com/2012/01/hot-air-on-drivers-side-vents-only.html

--------------

Temperature gauge does not move and no heat when heater is ON?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html

-----------

1992 Toyota Camry: A/C Control light Flashing and A/C not Blowing Cold?

http://technoanswers.blogspot.in/2012/04/1992-toyota-camry-ac-control-light.html

--------------

No heat, blower blows only cold?

http://technoanswers.blogspot.in/2012/02/no-heatblower-blows-only-cold.html

----------

Ford F150 Ac only blows through defrost vents?

http://technoanswers.blogspot.com/2012/01/forf-f150-ac-only-blows-through-defrost.html

----------

Dodge A/C come out of defrost vents only?

http://technoanswers.blogspot.com/2012/01/dodge-ac-come-out-of-defrost-vents-only.html

---------

Ac vacuum line on dodge cummins?

http://technoanswers.blogspot.com/2012/01/ac-vacuum-line-on-dodge-cummins.html

---------

Ford ranger AC blows cold through defrost vents instead on cabin vents?

http://technoanswers.blogspot.com/2012/01/ford-ranger-ac-blows-cold-through.html

----------

2005 Chrysler PT Cruiser: A/C Blows Warm?

http://whoisbyme.blogspot.in/2012/06/2005-chrysler-p8t-cruiser-ac-blows-warm.html

-------------

2009 Mercury Grand Marquis: A/C blows Cold From Defrost Vent Only?

http://whoisbyme.blogspot.in/2012/06/2009-mercury-grand-marquis-ac-blows.html

-----------

AC not blowing through Vents on 2007 Chevy Trailblazer?

http://schematicsdiagram.blogspot.in/2012/04/ac-not-blowing-through-vents-on-2007.html

----------

Passenger side temperature is warm air out of dash vents?

http://schematicsdiagram.blogspot.in/2012/04/passenger-side-temperature-is-warm-air.html

----------

These will help.

Thanks.

1st step is to check if the directional switch pointd down towards you-2nd step is to check yor fuse is not blown out-3rd step check your blower motor underneath the passenger side of glove box
hope that helps you out-good luck!

blower motor location is in the heater box down by the passengers feet the fan relay in out under the hood in the power fuse box check this first
check to see if the blower motor turns you can do this by removing the three screws the motor and squiral cage will come out spin it if it moves freely putit back replace the switch assembly

I already posted my solution.

hi one of your plastic vents has come of your main vent please check that all vents are ok in there right spots cheers peter