My starter won't stop cranking on my 2000 Chevy Silverado any suggestions?

SOURCE: 2005 chevy silverado won;t start.

i had the same problem, and it turned out the coil pack was moulding inside wich stopped the spark all together, i ended up changing my coil pack and putting on new wires because the ends connected to the coil were very corroded and that cures the not running part just fine


enjoy

SOURCE: 1998 chevy venture will not start only starter

battery is dead or too much corrosion on the terminals.

SOURCE: how to change starter on 2000 chevy silverado

These instructions are for a 5.3L. Unless it is a V6 or diesel, the instructions will be similar if you have a different gas V8.

1. Disconnect the negative battery cable
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the protective shields as necessary.
4. Remove the starter solenoid shield.
5. Remove the starter to transmission close out cover bolt.
6. Disconnect the engine oil level sensor connection.
7. Remove the front axle mounting bracket through bolt nut, if equipped with four wheel drive (4WD).
8. Reposition the front axle mounting bracket through bolt until the bolt tip is flush with the support bushing. Do not remove the bolt, if equipped with 4WD.
9. Remove the mounting bolts from the engine block.
10. Slide the starter forward until the starter clears the transmission.
11. Remove the starter transmission close out cover
1. Disconnect the positive battery cable and wiring harness from the starter.
2. Remove the starter from the vehicle.
1. Connect the positive battery cable to the starter. Tighten Tighten the nut to 16 N.m (12 lb in) .
2. Install the starter transmission close out cover.
1. Install the mounting bolts to the engine block. Tighten Tighten the bolts to 50 N.m (37 lb ft) .
2. Reposition the front axle mounting bracket through bolt until the bolt is fully seated. if equipped with 4WD.
3. Install the front axle mounting bracket through bolt nut, if equipped with 4WD. Tighten Tighten the nut to 90 N.m (67 lb ft) .
4. Disconnect the engine oil level sensor connection.
5. Install the starter to transmission close out cover bolt.
6. Install the starter solenoid shield.
7. Install the protective shields as necessary.
8. Remove the safety stands.
9. Lower the vehicle.
10. Connect the negative battery cable. Tighten Tighten the bolts to 17 N.m (13 lb ft) .

SOURCE: My 2000 Chevy silverado quit on my way to work, I

so you replaced the fuel pump because??? ck fuel pressure.

SOURCE: 1996 Chevy silverado won't start when wet out

I had the same problem and replaced the Dist. cap and rotor it had moisture in it and was corroded.
once replaced had no problems.