Question about 2007 Hyundai Azera Limited Sedan
The shifter clips in and fair amount of force is needed to remove it. a gentel knock with the hand will do the trick.
Posted on Jul 17, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jun 15, 2015 | Cars & Trucks
May 17, 2014 | 2006 Chrysler Pacifica
Feb 26, 2013 | 2005 Chevrolet Aveo Sedan
Oct 10, 2012 | Hyundai Santa Fe Cars & Trucks
Jun 16, 2012 | 2008 Mazda 6 2.0
Oct 06, 2011 | 2005 Pontiac GTO
This is a relatively common problem on these new Chryslre 300s.The failure is in the shifter assembly itself and it will need to be replaced. But for now, to limp around, you can actually still shift the car, you just cannot use the shifter.You will need to remove the center console and find where the shift linkage attaches to the shifter assembly. Remove the linkage and you can manually shift until you replace the shifter assembly.Here is how to remove the center console:
Apply the parking brake.Turn the ignition switch to the On position, apply the service brakes and place the gear selector lever into the Neutral position.Turn the ignition switch to the Off position and release the service brakes.Disconnect and isolate the battery negative cable.Remove the mat (2) from the cubby bin at the front of the floor console.Open the lid of the console rear bin and remove the mat (3) from the rear bin.Remove the two screws (1) that secure the front of the console shifter bezel to the console.Using a trim stick unsnap the console bezel from the console.Remove the shifter bezel from around the gear selector lever.
Remove the three 8 mm bolts (2) from the rear bin that secure the console to the floor panel transmission tunnel.Remove the two screws (3) that secure the front of the console to the instrument panel.Slide the console rearward far enough to access and disconnect the jumper wire connector (4) from the accessory power outlet on the underside of the console.Remove the floor console from the vehicle.-------------- Thankyou.
Apr 21, 2011 | 2005 Chrysler 300
Hope this helps (remember to rate and comment this).
Sep 25, 2010 | 1983 Chevrolet Camaro
May 09, 2009 | 1998 Toyota Corolla
Jan 20, 2009 | 2008 Chevrolet Cobalt
100 people viewed this question
Usually answered in minutes!