At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Fusible link and 200amp inline fuse on the main wire connected to the back of alternator ,this wire comes from the starter , This charging system is computer controlled . https://www.motor.com/magazinepdfs/092007_10.pdf
first need to buy oil pressure sending unit 3/8 deep socket remove oil pressure sending unit you need teflon tap sealer for oil sending unit threads.okay to replace oil pressure sending unit.you need safe raise support vechicle locate oil pressure sending unit next to the oil filter.disconnect oil pressure sending unit wire connector then use oil pressure sending unit 3/8 socket remove the sending unit.then take new oil pressure sending unit use teflon tape white plumbers tape or use thread sealer apply to the oil pressure sending unit threads then install new oil pressure sending unit and reconnect electrical connector to sending unit.then crank engine check for oil leak if all is good lower vechicle back to ground wait several minutes check engine oil level.you good to roll.
Location for OIL PRESSURE SENSOR'S are, on Engine BLOCK At 90 degree angle BEHIND OIL FILTER , And One Just Above the Starter Poking out Same Direction as OIL FILTER, I would Suggest that you Replace Both at the same time, this IS NOT MANDATORY, But I have found it to be a time-saver and Sometimes it IS Necessary to replace them Both. I Speak from 30 years to date of Experience turning them Wrenches LoL. I hope this is Of GOOD HELP to You, And Please dont forget to RATE US on Our Answers. Good Luck ! ,RejakWilson
It's on the engine, right next to the starter, it has one wire going to it. You don't need to drain the oil. If the light is coming on, you may have bad seals in the oil pan, a fairly common problem, but replacing the switch is a good fisrt step.
The oil filter on the 2008 Chevy Impala 3.5 V6 is located to the front center of the engine and recessed underneath and slightly to the right (passenger) side just behind the front frame crossmember.
×