SOURCE: how do you replace the starter in 1998 chevy malibu
The starter is very simple to replace, 1st always disconnect the battery, the wires at the starter are hot with 12 volts always present, remove the 2 attaching bolts for the starter to the engine block, then remove the wiring, one heavy cable and a bunch of smaller wires, one of those goes to the starter solenoid, mark it, the others are what are called fuse links and provide power to the rest of the car, clean up everything and then re-install in reverse order.
SOURCE: where does abs wire hook in to its just hanging dont no where to hook it into
wire goes to wheel bearing thanks pierre
SOURCE: how to replace valve cover gasket 1998 chevy malibu
The first step is to remove all the parts that are in the way of you being able to remove the valve covers. (Ex.: air intake, loose wires etc.) Then you will need to remove your valve covers (using basic tools) and be very careful to not let anything get on your lifters, which your valve covers protect. Once you have the valve covers off compare the new gaskets to make sure they are the right size. Then remove the old gasket and replace with the new one using a high temp gasket sealant (available at any auto parts store) to attach the gasket to the valve covers. Then tighten down snug and check for leaks after replaced.
SOURCE: I have three wires that run form the battery down
Your positive the red wire goes on the big bolt of your starter - You should have two smaller wires - One is from the distributor and the other is from the igniton. Hook these two wires up the same way you took it off. If you are not sure of how the wire came off and should go back buy a Chilton - It is not like re-wiring a light switch and it won't turn on if it isn't connected correctly - This could mess up your car if it isn't wired correctly!
SOURCE: Wiring Diagram 1998 Chevy S-10 starter replacement
The starter has one large cable from the battery positive, and a wire that goes to the solenoid (Part of the starter) that becomes hot when the key ignition is turned to start. This also passes through the neutral safety switch. (So it wont start in gear) Not sure if this is what you need, a little vague.
262 views
Usually answered in minutes!
×