Question about 2004 Ford Focus

1 Answer

I have a Fiesta Flame and the engine light is showing.

I have driven 30 miles and seems to be okay, but not sure what the problem could be

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 89 Answers

U have an engine management problem it will need to go on a computer

Posted on Jul 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why on my Ford Fiesta 1.4 2006 model after about driving 6kM does the analogue speedo dial stops reading and then after a couple of kM's after that the digital display goes blank?


I think you just have a failed dash display module, the whole thing is just a computer that takes info from sensors and converts it to readable analog data like speed, miles driven and so on for engine functions.

Jun 27, 2016 | 2006 Ford Fiesta 1.4

2 Answers

How to reset change oil soon light


Oil Life Monitor Resetting (KD, KE)
Description
The engine oil life monitor will indicate when to change the engine oil and the engine oil filter - usually between 5 000 km (3,000 miles) and 12 500 km (7,500 miles) since the last oil change. Under severe conditions, the CHANGE OIL message may be displayed before 5 000 km (3,000 miles). The vehicle must not be driven more than 12 500 km (7,500 miles) or 12 months without an oil change.
The engine oil life monitor will not detect dust in the oil. If the vehicle is driven in a dusty area, be sure to change the oil every 5 000 km (3,000 miles) or sooner if the CHANGE ENGINE OIL message is displayed.
Reset the oil life monitor when the oil has been changed.
Resetting Procedure
Press the INFORMATION SKIP button on the DIC control panel in order to display the OIL LIFE LEFT message.
Press and hold the RESET NO button until the display shows 100% ENGINE OIL LIFE.

Jan 29, 2016 | 1999 Cadillac DeVille

1 Answer

I refueled my tank 1995 Mercedes e320. In less than four miles the engine started to miss. I opened the gas cap and fuel spewed out. I have syphoned off fuel and driven it nearly 30 miles. There is no...


Sounds like you may have picked up some water at last refueling. Drain the tank or just drive the car till you get rid of all the bad fuel. U should go back to where you got the lousy gas and have them reimburse you. I did.

Sep 05, 2017 | Cars & Trucks

1 Answer

CHECK ENGINE LIGHT COMES ON AFTER DRIVEN ABOUT 75


get the actual code numbers

most of the trans codes are simply resolved with a trans flush and fill

Apr 13, 2010 | 1999 Mercury Sable

1 Answer

''Check Engine'' light on in '92 Camry V6LE I just bought..


fancy buying such an old car ,its way over its sell by date ,someone doctored this up thats for sure ,light could be anything bet bet is to take it to a garage and let them have a look

Dec 31, 2009 | 1992 Toyota Camry V6

1 Answer

Low oil when engine warms up gmc sierra 1995


30-40 psi of oil pressure is fine for many vehicles including your GMC. I am assuming that the truck has more than 100,000 miles on it and still has the original engine in it. By rule of thumb you only need 10 psi per 1000 rpms in a typical street driven engine to give adequate oil pressure to keep the bearings from oil starvation. The oil pressure is typically higher when initial start up occurs because it is more viscous due to the temperature of the oil as the engines oil warms up the visconsity thins out and the oil flows more smoothly. The drop in oil pressure is a normal occurance. Above 45 is more than required for a daily driven street engine. I believe that the specs on that engine only list 30- 45 psi.

Dec 07, 2008 | 1998 GMC Sierra

Not finding what you are looking for?
2004 Ford Focus Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...