You need to buy the entire tail light housing or if its the cyclops light in the center, you'll need to replace it as a whole part. You cannot replace individual leds on those parts.
SOURCE: How to replace map & dome light bulbs on a 2008 Ford F-150 Super
2008 Ford F-150 SuperCrew Cab (without moon roof or rails): How to replace the map light bulbs. First, you'll need a "trim pad remover." It is a tool with a screwdriver handle and the metal part has a 'smooth' forked tongue (see Snap-on Stock#: A177A for picture). Go to the center counsel and "gingerly" work around he counsel and pull down at the same time. The counsil is held in by six snap in tongs. It should remove pretty easily. once down, you'll see where the bulbs are. Unscrew and replace. Now, just line up the tongs and gently bump or hit the pressure points (where the tongs are) and it should snap into place. It should take no more than five minutes, tops.
SOURCE: replace power steering pump and lines 1992 cadillac seville sts
you need to have a pulley puller to get the pulley off if you don't have one most auto zone part stores have a loan a tool program and they can help you with that on most powersteering pumps the high pressure line will be a fitting or bolt on and the return line is usually just a squeeze clamp hope this helps good luck
SOURCE: 1995 Cadillac STS 3rd brake light OUT?
No it wouldn't be a fuse because it's partially still working,LEDs are wired in series so it could be one LED is burnt out or the current limiting resistor has opened for that section.Repairing it would be fairly simple but will require a multimeter preferably with a diode tester and a soldering iron.If you're not familiar with using a multimeter and testing electronic circuits I would say let a professional repair it or replace the whole unit.Comment back and I will give you the test procedures if you fell confident in making the repair.
SOURCE: left front turn signal bulb is out on my 2007
easily mabe. look down from under the hood, if not try try from underneath.
SOURCE: Unable to start car with remote.[Cadillac sts v
replace the battery in the remote.If this doesn't work look it the owners manual for reprogramming new keyfab follow the instructions. Good luck
281 views
Usually answered in minutes!
×