How do we lower the idle in a 2003Impala sedan? And how do we fix light inside console for high beam.

nothing should light up unless you are on high beam in which case there will be an high beam indicator on
there will be background lights to show the gauges ( so that you can see them at night)

Check the relay that powers the high beam, if memory serves me the relay is shared between those two circuits.You can swap the relay with a known good relay to prove if that is the issue.

You can not have High Beams on and FOG LIGHTS at the same time. The Body Control Module controls this. You may have a bad Body control Module

I have a 2008 Pontiac Grandprix GXP I had hit a deer in May the repairs were made in June of this year. Here is my problem the air bag light comes on while I'm driving the car and now I have no low beam lights. I have taken the car back to where the repairs were done, cause I think the problems are from the damages. I was informed today that there's no juice from the fuse box to the low beam switch. What would cause this?

No, you haven't missed anything I can think of, but the fact that it was intermittent, then permanent tells me that somewhere therein lies the answer. I admittedly don't know anything at all about "the orange light control relay", but it seems that if that's the problem it would probably affect both sides. Sorry I can't be more help. . .

I drive a 07 Grand Prix and the low beams randomly went out. Could not get them to come back on, but all of the other lights worked (inside, parking, and high beams). found a forum online that recommended replacing the fuse/thing at location #35 in the fuse box under the hood. It worked immediately!! Got the part at Advanced Auto parts for $35 dollars.

Not very clear as what your problem is...
Headlights run off their own fuse, as they require more power to function, parking lights run off a lower current fuse, what dashboard light stays on, the high beams?
Please reword problem.

my durango does that too, its either the multi function switch (turn signal arm) or light switch, i haven't fixed it either

I have a similar problem. The adjustment screw adjusts both the high and lof beams. After changing the passenger side low beam, both sides then pointed at the ground. High beams were fine. I adjusted so the low beams are fine but now the high beams point straight up.

In talking with Subaru Service he said there is a "module". He said after changing the bulbs they should point down then auto-adjust back up. That didn't happen. I haven't found anything on such a module. He said it woul be $109 for adjusting the lights OR for the module.

If I find anything more I'll let you know.

left to right...
1. empty
2. e flashers
3.horn, brake lights
4.clock, trunk light, inside light, radio
5. rad. cooling fan relay (AC only)
6. right side running lights
7. left side running lights
8. right high beam and indicator
9. left high beam and indicator
10. right low beam
11. left low beam
12. reverse,turn signal and inst panel
13. main and transfer fuel pumps, auxiliary air reg., ox sensor heater
14. license plate and glove box light
15. wipers
16. rear defogger
17. heater blower (no AC)
18. cig lighter
19. rad cooling fan (no AC)
20. Heater blower (AC)
21. rad cooling fan (AC only)
22. empty
23. Ox sensor, idle stabilizer,seat belt warning relay, (Digifant only, control unit, idle boost control, idle boost valve)
24. inst panel lights, heater control lights
25. reading lamps
26. empty
27. empty
28. empty

Hope this helps...;-)