Question about 2008 Chrysler Sebring Convertible

1 Answer

How to remove backseat on sebring 2008 convertable to fill pump

How hard is it

Posted by on

  • danguasp Mar 15, 2016

    Did you get this problem fix. The pump is in the trunk in the spare tired compartment to the back.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 75,814 Answers

The only reason the pump will be low is a leak, that fluid will destroy the body seam sealers if the leak is left unrepaired.

Posted on Jun 28, 2016

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 29 Answers

SOURCE: how do i change the digital clock on the 2008 sebring?

there should be a "H" and a "M" on the console with a small hole beside it,use a pen to push the recessed buttons

Posted on May 06, 2009

  • 1 Answer

SOURCE: 98 sebring jxi convertible. water pools in my back floor board

Sebring Convertibles have weep holes under the body that get clogged with debris and cause the water to back up into the floor. Take a paper clip and straighten it to clean out the weep holes. The weep holes can be found just under the frame at the doors where there is a seam(about where the jack would go). Along this seam about ervery 12 or 16 inches there will be a small slot for the water to drain.

Posted on Sep 29, 2009

  • 194 Answers

SOURCE: transmission leaks and I want to remove

very hard if you try then go buy a repair manual cause your gonna need it.read the manual first to see if you can do it. it may save you a big headache.

Posted on Nov 20, 2009

GodBlessU
  • 3513 Answers

SOURCE: i have to replace a

Hi


There are two black wing nuts in the trunk, twist them off. There is also a white clip that is holding a small post. Loosen the wing nuts. Place a small screw driver (flat) between the post and the white retainer clip, the whole assembly will pop off. Twist the housing that is holding the bulb and replace the bulb.
As per the owner's manual:-


1. Remove the two plastic wing nuts from the tail lamp
housing.
3. Grasp the tail lamp and pull firmly outward pushing
gently on the studs from inside to disengage the lamp
housing.
4. Twist and remove socket from lamp.
5. Remove bulb from socket and replace


Also check this link to have some helpful information:-

http://www.ehow.com/how_6392279_change-lights-2007-chrysler-sebring.html


Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com

Posted on Jul 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Chrysler Sebring hard top convertible goes halfway back to open then stops in the middle of the cycle.


There are many possible causes of this problem on the convertible Sebrings, the most common problems are as follows;

1) The cargo platform in the trunk is in the wrong position which blocks the rear window from folding downward. Ensure that the cargo platform is in the down position before attempting to operate the top.
2) The Hydraulic pump is low on fluid, it is located in the trunk, in the left rear corner, underneath the carpet. Inspect the fluid level in the reservoir.
3) There is an electrical fault in the system.
4) There is physical damage to one of the panel pivots, inspect for panel binding while the top is moving.

A couple questions for you;

When the top stops moving can you still hear the pump running or does it go quiet?

When the top stops moving does the cluster display "convertible top in operation" or "convertible top malfunction" or something else?

Report back with anything you find or if you need further help.

Nate

Aug 26, 2015 | 2008 Chrysler Sebring Convertible

1 Answer

Belt diagram routing


go to www.automecanico.com translate this web with your browser
and get the topic.
God bless you

Jul 29, 2013 | 2008 Chrysler Sebring Convertible

1 Answer

Where and how to reset the auto shut off the fuel pump or gas pump on 1996 chrysler sebring convertible


Chrysler does not use inertia/reset switches.the fuel shut off switch is under the backseat.

Is your Car not starting? Maybe your Fuel Pump is bad

Apr 05, 2013 | 1996 Chrysler Sebring

1 Answer

2008 sebring convertible when top is up trunk will not close


Mine took several hard slams to latch, with top up or down. Finally got dealer to adjust the latch which they originally said wasn't possible. Wore grooves into the latch rod while it was out of adustment, but at least now it closes.

May 03, 2011 | 2008 Chrysler Sebring Convertible

2 Answers

Were is the fuel pump at on a sebring


FOR SEBRING COUPE YOU CAN REMOVE REAR SEAT CUSHION.YOU WILL SEE ACCESS COVER ON TOP FUEL PUMP.REMOVE ACCESS COVER YOU WILL SEE FUEL PUMP MODULE. SEBRING CONVERTIBLE YOU HAVE TO REMOVE FUEL TANK TO REMOVE FUEL PUMP.

Nov 02, 2010 | 2000 Chrysler Sebring

1 Answer

How to service chrysler sebring convertible top hydraulic pump


if anyone has a 2008 chrysler sebring and need to add hydrolic fluid to a convertable pump the pump IS NOT BEHIND THE SEAT BUT IN THE SPACE WHERE THE SPARE TIRE IS LOCATATED it is mounted to the wall between the tire and the back side of the place where the tire is mounted take up the floor cover and you will see it

Jun 10, 2010 | 2004 Chrysler Sebring

1 Answer

Just replaced fuel pump in a 1996 chrysler sebring convertable 2.5 liter. fuel gauge is now stuck between half and a quarter.


sounds like float is stuck in tank,either remove pump again or try filling tank and drive your car swerving it to unstick float assembly

Nov 28, 2009 | 1996 Chrysler Sebring

2 Answers

98 sebring jxi convertible. water pools in my back floor board


Sebring Convertibles have weep holes under the body that get clogged with debris and cause the water to back up into the floor. Take a paper clip and straighten it to clean out the weep holes. The weep holes can be found just under the frame at the doors where there is a seam(about where the jack would go). Along this seam about ervery 12 or 16 inches there will be a small slot for the water to drain.

Sep 21, 2009 | 1998 Chrysler Sebring

1 Answer

2008 sebring hard top convertible top won't close.


This same thing has happened to me. Did you find an answer???

Apr 25, 2009 | 2008 Chrysler Sebring Convertible

Not finding what you are looking for?
2008 Chrysler Sebring Convertible Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...