Question about Ford Cars & Trucks

1 Answer

Where is the fuil injector fuse at for a 1999 ford tourus

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 451 Answers

No such thing. Do you mean fuel pump? Need more info to help

Posted on May 03, 2015

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Molson02536
  • 3854 Answers

SOURCE: my 2000 jimmy will not

Sounds like a bad ICM (Ignition control module). You can remove it and have it tested at Auto Zone or Parts Source before you buy the replacement ICM.

Good luck and thank you for using fixya, keep us posted.

Posted on Dec 07, 2010

chuckster57
  • 1102 Answers

SOURCE: how to reaiper or replace a fuil leak, #5 fuil

It depends on where the leak is. there are "O" rings at the top and bottom of each injector. If that's where the leak is, then the "O" rings are not very much and it shouldn't take that long to remove the "fuel rail" and replace the bad rings. I would suggest that if it is the "O" ring, then you would be wise to do ALL the "O" rings at the same time. Parts for this service should be available at most auto parts stores.

All the injectors use the same "fuel rail" and it is bolted onto the intake mannifold in most cases. There are clips that hold the injector into the "rail". Juat make sure to blow out the area where the injectors go into the engie so that no dirt gets into the engine. Carb spray helps "lubricate" the "O" rings and makes is easier to remove and install them.

Posted on Jan 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No fuil to injection on 5 L. straight 6


4.9L IL6, no fuel pressure? no injector pulse? what is the specific problem?

Jan 04, 2011 | 1991 Ford F150

1 Answer

My 2000 jimmy will not start replace fuil pump crack sensor.fuil get to injector.but injector dose not open put noid light on harness but light dose not come on.checked all fuse.an they r good an relays r...


Sounds like a bad ICM (Ignition control module). You can remove it and have it tested at Auto Zone or Parts Source before you buy the replacement ICM.

Good luck and thank you for using fixya, keep us posted.

Dec 07, 2010 | 2000 GMC Jimmy

1 Answer

I have a 1997 nissan sentra that wi have a 1997 nissan sentra that wont pass emisions fuil system lean bank1 p0171 code so i changed the maf sensior,fuil pressure reg, pcv valve, and all four fuil...


Have you checked your fuel pressure at the fuel rail? The problem could be a clogged fuel filter, pinched fuel line, or under-performing fuel pump (either faulty part, or not receiving enough voltage).

The only other thing I can think of that would cause the loss of power symptom and failing e-test would be a plugged catalytic converter, but that wouldn't likely cause the lean running.

Jun 27, 2010 | 1997 Nissan Sentra

2 Answers

Problim starting


check your mass air flow sensor. There is a thin filliment in it check to see if it is dirty.

Mar 18, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

No start


NO, it will not cause an air lock in the fuel system. It can cause a hydraulic lock in the affected cylinder however. A leaking fuel injector or a leaking injector cup can allow air to enter the fuel system.

Oct 17, 2008 | 1996 Ford F350 Crew Cab

2 Answers

1999 ford taurus


check the fuel pump itself.. if no fuel going through lines... injectors won't work.

Aug 16, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...