Question about GMC Cars & Trucks

1 Answer

I need to replace my tail lights on my GMC S15 and I can't take the one's out so I can put the new one's in can u please tell me how can I remove the old one's

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 744 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
wickedsteele
  • 56 Answers

SOURCE: Replacing the tail light

Look inside behind the light and see if there is an access cover, if not you will have to remove the tail lamp to replace the bulb. If you open the rear hatch and look at the lamp you should see a couple of screws that hold the lamp to the car. Remove these and pull the light out.

Posted on Aug 10, 2008

  • 203 Answers

SOURCE: Replacing the tail lights of our 2005 Nissan Murano?

if the lite cover has no screws the access is in the boot pull back the boot/trunk carpet and you should see a cover over the tail lites access should be through there

Posted on Nov 21, 2008

  • 87 Answers

SOURCE: what to set timing using timming light

0 degrees BTDC would be the spec , there is a brown w/tan tracer wire near the distributor , you have to disconnect the connector before setting timing

Posted on Feb 06, 2009

cabrooksjr
  • 13 Answers

SOURCE: 93 GMC Suburban, No Tail Lights

Check the trailer plug ground first. If in doubt. Ground in another location. Make sure the area is free of rust and the ground is tight.

Posted on Jun 28, 2009

  • 142 Answers

SOURCE: need to change fuel pump on 2004 GMC Yukon XL

well i hope its not full of fuel, remove the filler neck from the car should be 3 bolts by the fuel door, there will also be a ground cable up by thefuel door to remove, next you will have to remove the two straps that hold the fuel tank up slowly lower it as you will have fuel lines and elctrical plugs that need to be detached, the fuel lines have quick fittings, you can buy a tool at auto stores to make removing them easier, un plug the wires., once the tank is out there is a snap ring holding hte fuel pump in the tank. taking a hammer and small drift turn the ring this will release the sending unit, so that you can instull the new one, now reassemble

Posted on Sep 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tail lights stopped working and dash light inside truck changed fuse and looked for any loose wire not sure what happen any one know what it may be (GMC S15 1986 Pickup)


Check all fuses under dash and under hood with test light.Check fuses in place.Turn ign and light switch to on when checking fuses.

Apr 12, 2017 | GMC Cars & Trucks

Tip

How To Install Replace Headlight and Bulb 98-04 GMC Sonoma S15 1AAuto.com


How To Install Replace Headlight and Bulb 98-04 GMC Sonoma S15 1AAuto.com


on Feb 21, 2012 | 1998 GMC Sonoma

1 Answer

How do i fix 2002 s-10 tail light


This was posted in PC Laptop problems so I have no idea how to fix cars lol. Try this link How To Install Replace Taillight Chevy S10 Pickup GMC S15 Truck 98 04... It looks like its what you need.

Feb 10, 2014 | Cars & Trucks

1 Answer

I need the fireing order for a 2000 sonoma 4.3 vortec and when i put the gas pedal to the floor it bogs down i just did a complete tune up and it still does it and no engine light is on


2000 GMC S15/T15 Sonoma P/U 4.3 liter V-6 VIN "X"
and
2000 GMC S15/T15 Sonoma P/U 4.3 liter V-6 VIN "W"


zjlimited_213.gif


Hope helps (remember to rate this answer).

Feb 25, 2011 | GMC Sonoma Cars & Trucks

1 Answer

Replace u joint on GMC S15 pickup


You'll need a bench vice for this. A few sockets help as well. Once you get the shaft off the truck, put a smaller diameter socket on one side and a much larger diameter socket on the other and sandwich in a vice. Compress vice to drive the U-Joint through shaft (smaller socket will drive the one side through the other with the much larger socket). Installation is the reverse of removal.

Apr 24, 2010 | 1988 GMC S-15

1 Answer

How do i replace the tail light bulb?


to replace the GM tail light bulb, you will drop down the tail gate and you will notice 2 screws on the tail light assembly, you will remove those 2 screws with the proper screw driver, once you do that the whole tail light assembly will come off, then you will see onother 2 screws holding the light panel to the tail light assembly, or brackets holding the light panel to the tail light assembly remove either or and you will have access to the three bulbs on that light panel, replace the burnt one and follow the same intrunctions to put back.

Apr 06, 2010 | 2005 GMC Canyon

1 Answer

Change Ignition Switch in 1987 GMC Jimmy S15 4x4


if you want to change ign switch it is bolted to the steering column if you want to replace the key lock cyl you need to remove steering wheel and turn signal switch but you need special tools to do that

Jan 31, 2010 | 1987 GMC Jimmy

4 Answers

Brake lights won't work. tail lights do. I


need to know if your third brake light up high is working or not.if it isn't,you need to check the brake light switch on the brake pedal with a test light,one side hot all the time,the other side should turn hot when brake pedal is pushed.

Jan 19, 2010 | 2002 GMC Envoy XL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...