Question about Cars & Trucks
Have the alternator bench tested as it is not keeping up to the power requirements of the electrics.
check drive belt condition and tension.
Posted on May 03, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If you are speeking of the check engine light you can disconnect the battery for a few minutes then reconnect it and the light should go off.
Posted on Jan 28, 2009
SOURCE: Torque specs for mighty max
Per my Chilton's manual tehe bolts should be (cold engine) 65 to 72 FT. Pnds., the cam shaft bearing bolts should be 8x25 = 15 - 19 Ft pnds and the 8x65 should be 14 - 15 Ft Pnds.
The sequence is as follows for the (10 ) head bolts:
7 - 5 - 2 - 4 - 10
9 - 3 - 1 - 6 - 8
I hope this may help,
Posted on Oct 15, 2009
The turn signals and break lights are on the same circuit, if both turn signals fail to blink, the problem may be due to a blown fuse, a faulty flasher, a broken turn signal switch assembly , or loose, broken wire.
Posted on Mar 14, 2010
I suspect a bad multi function switch located in the left hand side of the steering column. This switch controls your high/low beams/wiper delay/windshield washer/turn signals and hazards.
Posted on Apr 04, 2010
Tips for a great answer:
Oct 10, 2016 | Volvo 850 Cars & Trucks
May 02, 2015 | Cars & Trucks
Jan 16, 2015 | Mitsubishi Cars & Trucks
Apr 22, 2011 | 1992 Mitsubishi Mighty Max
Mar 10, 2011 | 1995 Mitsubishi Mighty Max
May 17, 2009 | 1995 Mitsubishi Mighty Max
Jan 28, 2009 | 2003 Ford Ranger Regular Cab
Oct 17, 2008 | 1993 Chevrolet Suburban
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: