Question about 1996 Ford Taurus

1 Answer

WHERE IS THE DPEF SENSOR ON A 96 FORD TARUS - 1996 Ford Taurus

Posted by on

  • Ed Warden
    Ed Warden May 20, 2015

    Your DPFE sensor should be on the top of the engine, usually near the intake manifold, should be a gray rectangular box with an electrical plug and 2 hoses going to it, usually the hoses plug into the bottom of it

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 21,873 Answers

Usually mounted near the EGR valve.
Just follow the hose from the EGR tube.

Posted on May 21, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 740 Answers

SOURCE: how do you change the spark plug wires for the

from under the car is the best way

Posted on Mar 05, 2010

alicantecoli
  • 22265 Answers

SOURCE: i need a diagram of 96 ford tarus battery

negative earth

Posted on May 03, 2010

  • 39 Answers

SOURCE: 95 ford tarus wagon 3.8 won't start. Air Flow Sensor?

u may need to have ur computer reset, u dont say if u have any warning lights on the dash. other fuelling system sensors tie in with the air flow sensors. plug ur diagnostic port in at a garage and see what fault code reads.

Posted on Jun 19, 2010

  • 21 Answers

SOURCE: i need a diagram for

firewall

3 - 6

2 - 5

1 - 4

front



Read more: http://wiki.answers.com/Q/Where_is_cylinder_number_5_on_a_ford_3.0#ixzz1HBP0f5J7

Posted on Mar 20, 2011

  • 691 Answers

SOURCE: I can't get hot air

It sounds like vacuum is not getting to the vent, heat and A/C controls. Find the vacuum can. It may be under the hood on one of the inner fenders. The "one-way" check valve is usually located in the line and close to the can, make sure it works properly. The valve could be the very thing that's causing the problem. Trace the lines back to the vacuum block at the intake manifold or fire-wall, and also back to where the line goes thru the fire-wall. Check the can for leaks or obvious holes. They used to be just a plain metal can, but it could be a plastic ball. Check the lines as you go, for breaks and rub-thru's. Move the controls thru all settings and listen for vent door movement. Worst case is a bad vacuum motor or air flow position selector switch, and/or a faulty Blend Door Actuator. If you have been driving around with the Temperature knob or control set at the same spot for months, move it from fully cold to fully hot several times and wait for the air temperature to change each time. This will help reset the blend door and vacuum control system. Hope this helps... Let me know what you find.

Posted on Sep 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of coolant sensor 2000 ford tarus station wagon 3.0 liter v-6


Not sure I follow you.
The engine temp sensor sends a signal to the engine computer and the computer decides when to activate the fan relays. So if you have power to the fans you would also have power to the high or low speed relay the temp sensor is probably working. There is a third relay for the ground circuit.

Jul 07, 2013 | Cars & Trucks

1 Answer

Were is the crank sensor located on a 2000 ford tarus


Most crank sensors are located somewhere or near to the crankshaft or sometimes near the camshaft. Trace the wiring harness down to the bottom part of the engine around the harmonic balancer. It should be near it. Hope that helps.

Nov 27, 2012 | 2000 Ford Taurus

1 Answer

Where is the tempoture sensor located at on a 1996 Ford Tarus


Hi there,

The coolant temperature sensor of your vehicle is located on top of the intake manifold.

Glad to be of help...

Jan 23, 2011 | 1996 Ford Taurus

1 Answer

95 ford tarus wagon 3.8 won't start. Air Flow Sensor?


u may need to have ur computer reset, u dont say if u have any warning lights on the dash. other fuelling system sensors tie in with the air flow sensors. plug ur diagnostic port in at a garage and see what fault code reads.

Jun 17, 2010 | 1995 Ford Taurus

1 Answer

Where is the dpef senor located on a F15 Ford Truck 1999 4.6 L , Can I replace it my self. Should I change all senors to stop the problem


on top rear of engine, it's a rectangular box next to EGR valve. it has a connector and two hoses connect to it.

Mar 05, 2010 | 1999 Ford F150 Regular Cab

1 Answer

96 Tarus Running Hot


Check the water pump.I have seen the impellers corode off.Also check for factory recalls on this vechicle.

Aug 26, 2009 | 1996 Ford Taurus

Not finding what you are looking for?
1996 Ford Taurus Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5575 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...