Question about 2006 Nissan Altima

1 Answer

Car will not go into drive after i start it up

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 5,432 Answers

Check brake switch that must be depressed in order to shift gears.

Posted on May 01, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the drive cycle for a Sante Fe 2005. I don't know how to do this. Fixed all codes and now it says drive cycle


what is a drive cycle for a 2005 santa fe. the battery was - JustAnswer

https://www.justanswer.com > Car Questions > Hyundai Questions
Aug 4, 2012 - I have the graphic for the drive cycle for your car. graphic. I will explain the steps. Fuel tank 1/2 tank. Do not turn key on before starting drive cycle that day. Do not turn car off during drive cycle. Have second person in car to read instructions and watch time. Obey traffic laws and be safe. Cold start engine and ...

Hyundai Santa Fe Questions - What is the drive cycle on a 2008 ...

https://ca.cargurus.com > Questions > Hyundai > Santa Fe To perform an OBDII Driving cycle do the following: Cold Start. In order to be classified as a cold start the engine coolant temperature must be below 50°C (122°F) and within 6°C (11°F) of the ambient air temperature at startup. Do not leave the key on prior to the cold start or the heated oxygen sensor diagnostic may not run.

Hyundai Santa Fe Questions - What is the drive cycle sequence for a ...

https://ca.cargurus.com > Questions > Hyundai > Santa Fe Sallybg asked the same question on Mar 06, 2013 for a 2008 Santa Fe. Judge_roy responded. His solution also worked on my 2007 Santa Fe. His response/solution was as follows: To perform an OBDII Driving cycle do the following: Cold Start. In order to be classified as a cold start the engine coolant temperature must be ...

Feb 13, 2018 | Cars & Trucks

3 Answers

How do i get started


put in key and turn right

Dec 02, 2015 | Cars & Trucks

1 Answer

Car shut off for no reason while driving


Your car should not turn off while driving, After your revived car has been running a few minutes, turn off the engine and see if it will restart on its own, no cables attached. If it starts, you should be okay.-------------------------------------------------------------------------------
KWP2000 Plus ECU REMAP Flasher Tunning

Feb 23, 2013 | Cars & Trucks

1 Answer

Car overheats in drive when stopped


Do you know if the cooling fan works ?
Have you checked the coolant level in the radiator ?

Jun 29, 2012 | 1991 Buick LeSabre

1 Answer

03 monte carlo ss won't start after driving a


If you are driving the car and it wont start after driving awhile. Do a wiggle on the CKP (crank position sensor) this sensor is located at the front main engine pulley, I am seeing a lot of loose male to female connection shut car off.

Feb 28, 2012 | 2003 Chevrolet Monte Carlo

3 Answers

Drive 5 miles and starts up fine, drive 30 miles and wont restart


Sounds like a fuel pump overheating. Drive until it wont start then check the fuel pressure. If no gauge when it wont start try some starting fluid. You should also check your fuel pump relay.

Jun 07, 2010 | 1994 Ford Taurus

1 Answer

Start car & put in drive start to drivr &


Could be fuel pump, could be trans or torque convertor issue causing this. Are you getting any MIL or Check engine light??

How many miles since last tune up??

Apr 21, 2010 | 2000 Dodge Durango

1 Answer

2001 mazda 626


broke drive axle?..any clicking or clunks associated with this happening?

Jul 01, 2008 | 2001 Mazda 626

Not finding what you are looking for?
2006 Nissan Altima Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...