Question about 2000 Ford Excursion

3 Answers

Went to start my car and NOTHING...no lights, sounds etc.. play with it, lights turn on.. I turn on the ignition and the entire car goes dark again... what is it?

Posted by Anonymous on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Dead cell in battery-Its happened to me more than once. Enough juice to run lights even down a cell, but trying to start WAY overloads it and puts you in dark.

Posted on May 01, 2015

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Ford Expert
  • 207 Answers

First step;
INSPECT BATTERY ELECTROLYTE LEVEL
INSPECT BATTERY RESTRAINT
INSPECT BATTERY CABLES/TERMINALS
LOAD TEST BATTERY
INSPECT BELT
TEST ALTERNATOR OUTPUT

If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

Posted on May 01, 2015

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,438 Answers

Bad battery connection most likely.

Posted on May 01, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My Cadillac cts 04 won't start... Every time I turn the key it won't even turn over... But the light that shows a car with a lock on it blinks what do I do


Sounds like the anti theft system is active m try this process. Turn the key on. Do not attempt to start. Wait 10 minutes. Turn key off. Turn key on. Wit for theft light to go off. Now attempt to start.

Oct 25, 2016 | Cadillac Cars & Trucks

1 Answer

Bad ignition switch


I had the same thing happen to me with my 2002 Sable GS. Drove it home from work about 35 miles and shut it off. % hours later needed to run some errands and the car did nothing, did not start and there was no clicking. I cleaned my battery terminals ( the were dirty and dark colored but not your typical battery corrosion .. white chalky looking) and placed a battery charger on it and it started. I hope this helps someone.

Oct 11, 2017 | Mercury Grand Marquis Cars & Trucks

1 Answer

Won't start


Check alternator fuse , it's should be a high amp fuse . Question is did you give some one a jumb start , this could happen , another thing to check is your ignition fuse and your ignition switch , but first check all fuses . Including the big once under the hood and inside the car . Good luck and I hope this helps

Jan 15, 2013 | Cars & Trucks

1 Answer

My 2005 Jeep wrangler suddenly would not start yesterday after several trips around town. I turned the key it made a funny noise then nothing except all the dash gage arms were jumping around making a...


probly need a new batt if over 3 yrs--it has scewed ur computer up--do a tuneup-chec plug wires-clean throttle area-test alternator now cause a bad batt cant ruin it--also inspec trans fluid etc-get a haynes manual at parts place

May 14, 2011 | Jeep Wrangler Cars & Trucks

1 Answer

2003 Trailblazer- no power after key stuck in ignition


Sounds like an antitheft problem I would start with the antitheft system. Usually when you only have one key all keys have to be programmed together even the original. When you have more than one it is easy to program additional keys.

Apr 11, 2009 | 2003 Chevrolet TrailBlazer

1 Answer

2004 Grand Am wont start, doesnt even make a clicking sound...


This sounds like the Ignition Starter Switch. It should be on the left side of the steering column.....right under the steering wheel. If you go to an auto parts store they should be able to show you what the part looks like.

Thanks,
Andrew

Jan 17, 2009 | 2004 Pontiac Grand Am

1 Answer

Ignition key turns on but car will not start


I suspect the ignition switch is malfunctioning.

Nov 19, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Excursion Logo

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...