Question about 1987 Toyota Pickup

1 Answer

Hey I have a 1987 toyota pick up just change my starter and battery run for a week and know it pops a fues when trying to start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 272 Answers

Which fuse is popping? That particular fuse that is popping is either shorting or getting a sporadic ground. Hope this helps.

Posted on May 01, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mmptruck
  • 124 Answers

SOURCE: 1994 Toyota Pick-up will not start.

Could also be battery cable to starter (The thick one) check connections are solid.

Posted on Aug 03, 2008

  • 1 Answer

SOURCE: Now what? Changed alternator but car still won't start.

Is this the solution for a starter motor that whirs and does not engage?
Coincedentally the bottom water hose of the radiator leaks, so must have been running hot.
Favourite son did not notice this!!

Posted on Nov 01, 2008

fixyathing
  • 341 Answers

SOURCE: How do I change the starter in a 2000 Toyota Camry LE

i'm sure it's not the starter itself that is the problem, have the stater's solenoid checked...it might be stucked. It's quite a lot of work removing the starter but you can do it if you are willing enough to learn. You just need the right idea and tools to do it. Hope this will help save you bucks!

Posted on Aug 10, 2009

  • 38 Answers

SOURCE: 1987 toyota camry was running wont start, will not

Try moving gear lever from park to neutral then starting, if does not start check starter relay, solenoid or ignition switch, contacts could be worn

Posted on Aug 11, 2010

  • 215 Answers

SOURCE: i have a 1990 toyota

the wiring harness under the truck on the d side may be laying on the exhaust and it goes to the o2
sensor and also if it is a 4 cylinder it could be the harness laying across the fuel rail shorting to ground on the rail.

Posted on Jun 16, 2011

Testimonial: "you nailed it thank you so much dat was problem thanks again"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New starter and battery, and no power on a 2003 Toyota Corolla


I am not familer with this exact car but 2 things to look for, Many of the Jap cars have a main fuses. usually located near the battery, ina small fues box there will be a wire that attaches to the positive batt cable that goes to this little fues box It usually powers the IGN circut which powers the starting circut. .. on Americsan cars they use a fuseable link which is a piece of wire that burns out when a live positive wire is shorted out. in place of burning the whole wiring harness. its easy to see this problem since the wire will be burnet in half..

Being that this happened tells me that you have a short probably at or near the starter.that is blowing the fuse or burning the fuseable link. Look for this short or it will just burn out the fuse again.

May 12, 2014 | Toyota Corolla Cars & Trucks

1 Answer

Mini Wini on a 1987 Toyota. New battery. Won't start.


Well if you replaced the starter solenoid it sounds like something as simple as a bad battery connection,I would take both battery cables loose and clean them off with something like some 100-150 grit sandpaper or they make a battery and battery wire connection cleaning tool.

Apr 08, 2010 | 1987 Toyota Pickup

1 Answer

How do know if the blower motor from my 1987


Should have one positive and the other negative. rig a jumper wire from the battery .one conductor + the other -. Clamp the unit in a vise or hang on ! as the torque when/if it starts will make it roll.If it runs its ok. simple as that! chibasset

Oct 27, 2009 | 1987 Toyota Pickup

3 Answers

1988 22re toyota pick up


You may need to pull the starter,alot of times when they remanufacture a starter they just do a basic test on the solenoid and if it checks they don't replace it.Toyota starters use a bell shaped copper contact that is prone to wear and corrosion,I drive a Toyota myself and had this exact problem.

May 28, 2009 | 1987 Toyota Pickup

3 Answers

My daughter's 1987 4 runner won't start after driving some.


bad fan relay.see if your radeater has good flow. if you keep running it like that you will lose your motor

Apr 05, 2009 | 1987 Toyota 4Runner

1 Answer

1987 Toy P/U JUST QUIT TURNING OVER


Yes, that would be the Starter. It is on the Lower part of the Motor on the Passenger Side. Should not be that hard to Change out.

Jan 12, 2009 | 1987 Toyota Pickup

1 Answer

My 1992 toyota standard pick up wont start


Check the connections at the starter and battery agian before you start looking to replace the starter.

Nov 05, 2008 | 1987 Jeep Wrangler

1 Answer

No start conditon


Hey there lucifer823,

Yes, it's electrical.
Let's narrow it down a bit. This procedure will either locate or rule out 90% of starter problems.

Checking Starter function:
  • Run a wire (at least 12 ga w/ alligator clip) to the START terminal (the smaller one, not the battery connector) of the Starter Solenoid.
  • MAKE SURE IT"S IN NEUTRAL OR PARK, IGNITION OFF, SET PARKING BRAKE. Priority one - Safety
  • Make sure you and any tools are clear of moving engine parts. Check again that the IGNITION is OFF. Momentarily touch the other end of the wire to the positive battery post.
  • The starter should turn over. If it does, leave the wire, it will be useful in upcoming tests.
  • If it doesn't, The starter or the solenoid is bad. Pull it.You can bench check the starter with jumper cables. Negative to the body, positive to the heavy terminal on the solenoid that goes to the starter. If the starter works, only the solenoid is bad (good news, they're cheaper). If it doesn't, replace the starter.
  • If it only clicks, the battery is low.
Let me know what you find out. We'll pick it up from there.

Remember: good things come to those who Rate

Mike

Aug 01, 2008 | 1987 Jeep Wrangler

2 Answers

Now what? Changed alternator but car still won't start.


a dropped/disconected starter solenoid cable is a good candidate, a heavy cable runs from the battery to the starter, a lighter cable runs from the ignition to the starter solenoid, the ignition key throws the solenoid which engages the starter pinion gear in the flywheel, and connects the cable to spin the starter motor. even loose may not be producing enoug current to fully engage the starter.
there is a fusible link in the battery cable that is a good candidate.
if the battery were disconnected during alternator changeover, look for loose cables at the battery posts, and corrosion on the posts.
if the battery was not disconnected look for collapsed positive plates on one or more cells of the battery..

Jul 13, 2008 | 1987 Toyota Corolla 2 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...