Question about Dodge Cars & Trucks

1 Answer

Location of flasher unit 2001 dodge pu 2500 ram

Where is the flasher unit located?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 48 Answers

A defective turn signal relay in the Ram 2500 can cause your signals to malfunction or stop working entirely. As a relay ages, so does its circuitry. However, the most common cause of relay damage is attributable to an electrical fault in a relative location, such as the taillight assembly. You can find and replace the turn signal relay in your Dodge Ram 2500 with a few common tools. You can do this job at home; it should take you less than 20 minutes to do.

Things You'll Need :

Phillips screwdriver

Socket wrench set


Instructions:

1. Open the driver's door on your Ram 2500. Reach beneath the front of the driver's seat and pull the seat release lever up. Push the seat toward the rear of the truck as far as it will go.

2. Kneel within the door opening so that you're able to see the bottom of the steering wheel. Below the base of the steering wheel you should see a large square piece of trim panel. This is your Ram 2500's knee-blocker panel.

3. Remove the screw on the top, left and right of the panel with a Phillips screwdriver. Along the bottom lip of the panel--horizontally--you should see three more screws. Remove the screws with your Phillips screwdriver.

4. Take the panel off to reveal your interior relay and fuse cluster. If your turn signal relay has never been replaced, it should be the only white relay in the cluster. If it was replaced before with an aftermarket relay, it will likely be black in color. The square turn signal relay sits on the top, outer right corner of the relay and fuse cluster. It pulls out of place and simply plugs back into position.

I hope this helps.

Posted on May 08, 2015

  • Cliff Hall May 08, 2015

    Problem resolved by replacing flasher unit located in fuse block. cost $20

  • Bradley Hubbard
    Bradley Hubbard May 16, 2015

    Excellent to hear, happy travels.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
RudolfDiesel
  • 100 Answers

SOURCE: flasher location for signals

Hello
Welcome to FY
It is located on the drivers side, at the left side of instrument panel located on fuse block. It simply unplugs. They are usually round about the size of a silver dollar with 3 plugs. Can be plastic or metal
RD

Posted on Jan 12, 2009

  • 701 Answers

SOURCE: where is oil pressure sensor located on 2001 dodge 2500 cummins?

Hello mhak330: My name is Roger and I can give you the answer to your question. Locate the ECM on the drivers side of the engine.look for the bottom bolt holding the ECM. To the right of the bolt you should see the oil pressure sender unit. Should you need further help please just ask. Please rate the quality of your answer. This way we know you received helpful information. Thank You for using Fix Ya. Roger

Posted on Jul 07, 2009

wilsodfarm
  • 986 Answers

SOURCE: how tro replace heater core in 2003 dodge Ram PU

dodge want $800 to$1000 for doing this and I can see why.You have to raise or remove the whole dash recover you a/c freon ,disconect your a/c lines and heater hoses remove your heater box and put on a work bench remove the top and remove heater core,now next the last one I did the new heater core will not fit you have to modify the box so your new heater core will fit,put it all back together and fill with coolant and charge a/c, man I got tirered just typing this much less doing it, I hope this helps

Posted on Oct 26, 2009

  • 1348 Answers

SOURCE: 2001 dodge ram 2500 v10 oil pressure drops to 0 then back up

you need to put an oil pressure gauge on it and see what happens.what you will find is that the sender unit is no good.

Posted on May 18, 2010

ZJLimited
  • 17970 Answers

SOURCE: Where is the filter located on a 2001 dodge ram

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L Turbo Diesel 6cyl the Fuel Filter is located under hood, passenger side, lower engine area, mounted above starter.

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L SFI 8cyl the Fuel Filter is located under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module.

Hope helps with this (remember rated the help).

Posted on Jun 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Signal light failure


sounds like you may need to replace the electronic flasher. it is a relay located typically in the fuse panel inside the vehicle

Jan 09, 2014 | 2001 Dodge Ram 2500 Truck

1 Answer

The brake ,hazard and turn signals do not work


I suggest first check FLASHER unit. On 2001 Dodge Truck RAM 1500 1/2 ton 4WD 5.2L SFI 8cyl the Flasher is located on seating area, driver side, at the left side ofinstrument panel on fuse block.

Hope this helps (remember to rating this free answer and leave a testimonial comment).

Oct 09, 2011 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Brake,hazard and turnsignals not working, headlights and tail lights work fine


I suggest first check FLASHER unit. On 2001 Dodge Truck RAM 1500 1/2 ton 4WD 5.2L SFI 8cyl the Flasher is located on seating area, driver side, at the left side ofinstrument panel on fuse block.

Hope this helps (remember to rating this free answer and leave a testimonial comment).

Oct 09, 2011 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

TURN SIGNAL FLASHER LOCATION FOR 1999 RAM 2500 HOW DO YOU REPLACE THE TURN SIGNAL FLASHER WITH THE HEAVY DUTY FLASHER #552 SO I CAN TOW A TRAILER


Hello Patty - Check the back side of the interior fuse box, should be between the steering column and the fuse box. You should be able to hear it "click" when in use. Most 2500 Rams had a flasher unit that was trailer ready. You may not need this upgrade. I hope this helps.

Oct 07, 2011 | 1999 Dodge Ram

1 Answer

Where is the heater fan located on my 2001 dodge 2500 diesel truck


Its located on the passanger side above the kick panel there are 3 bolts that hold it in the housing

Jul 10, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

Where is the filter located on a 2001 dodge ram


2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L Turbo Diesel 6cyl the Fuel Filter is located under hood, passenger side, lower engine area, mounted above starter.

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L SFI 8cyl the Fuel Filter is located under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module.

Hope helps with this (remember rated the help).

Jun 01, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

Where is oil pressure sensor located on 2001 dodge 2500 cummins?


Hello mhak330: My name is Roger and I can give you the answer to your question. Locate the ECM on the drivers side of the engine.look for the bottom bolt holding the ECM. To the right of the bolt you should see the oil pressure sender unit. Should you need further help please just ask. Please rate the quality of your answer. This way we know you received helpful information. Thank You for using Fix Ya. Roger

Jul 07, 2009 | 2006 Dodge Ram 2500

1 Answer

Sterring veers hard to right


have you tryed to rotate the two front tires side to side to see if the pull goes to the other side ?

Mar 29, 2009 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...