Question about Alfa Cars & Trucks

Open Question

Where can we activate inertia switch in alfa gt diesel?how it looks like

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: where is the inertia switch located on a pontiac 89

Answered

Posted on Nov 15, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I rear ended a vehicle in my 1985 Ford F150 manual transmission. I reset the inertia switch but I still can't get my truck to start. Any suggestions?


Was the inertia switch actually activated? If so the button would pop up. You need to determine whether or not there is a lack of spark or fuel causing the no start.You may have a defective inertia switch if it was activated and will not reset. You can unplug it and by-pass the wiring of the inertia switch by crossing over the wires at the plug to see if it will start

May 18, 2015 | Ford Cars & Trucks

1 Answer

Cannot locate alarm on 03 plate,1.9 jtd model,can't switch of


post the symptoms. "cant switch off what, exactly"?
the FSM covers the tests, ever heard of the FSM. (buy it at the dealer)
or alldata.com1.9JTD,
i get to decode JTD ,thanks for not posting maker , model
Is this a FIAT"? why must i guess.?
uniJet Turbo Diesel,
Some PSA Peugeot Citroen diesel engines are also rebadged JTD units.
Applications:

pick one, and state country?
some (most?) alarms vary by country (LAWS dictate that)

Jun 14, 2014 | Cars & Trucks

1 Answer

Fuel shut off switch location on a 74 alfa romeo spider 200


Does the fuel pump run? The inertia switch, if tripped will prevent the fuel pump from running. If the pump runs but the car doesn't start than it's likely a problem with the fuel pressure regulator or the bypass internal to the pump.

Jun 04, 2014 | 1974 Alfa Romeo Spider

1 Answer

No electric to fuel pump


Look in your trunk usually on the Drivers side for several switches. The switch you need to reset is called an Inertia switch and it is usually near the air-ride switch cutoff.

It is common for the Inertia switch to activate with an impact of the right frequency. The purpose of this switch is to kill the fuel in event of an accident, but sometimes closing the trunklid or a door can trigger it.

Dec 09, 2013 | 1999 Lincoln Town Car

1 Answer

Flight recorder data is stored.electronic throttle monitor data availabe code p1582


1 Inertia switch activated

2 Throttle Limp Home mode

3 Engine starts and stumbles

4 Engine fail to start
5 Engine stall

If none of the five conditions occur, check: Inertia switch to ECM circuit:

short circuit to B+ voltage Inertia switch failure

You can check the Inertia switch status on the Instrument cluster Diagnosis, see http://www.bluejag.co.uk

Jan 30, 2011 | 2002 Jaguar X-Type

1 Answer

Turned of car, will not start it turns over, but doesn't seem to be getting any fuel


Try A SMALL SHOT Of Starting Fluid Sprayed into the Snorkel
Intake @ Air filter. If it Starts and Does NOT Run After Burning Starting Fluid the Fuel Pump Has Failed. (My Personal Hunch) is (FUEL PUMP FAILURE) BE SURE TO ELIMINATE THE INERCIA SWITCH< it is a fuel shut off switch >>>>> WARNING: Do not reset the inertia switch button if you see or smell fuel.

  1. Turn ignition switch to OFF.
  2. Check for leaking fuel in the engine compartment, fuel lines and fuel tank.
  3. If no fuel is apparent, reset the inertia fuel shutoff switch by pushing the reset button on top of switch.
  4. Turn ignition switch to START for a few seconds, then to OFF.
  5. Again, check for leaking fuel.
LOCATION


  1. Open luggage compartment door.
  2. Remove two screws retaining inertia fuel shutoff switch.
  3. Disconnect wiring harness connector from inertia fuel shutoff switch and remove inertia fuel shutoff switch.
  4. To install, reverse removal procedure.

Aug 17, 2010 | 1996 Mercury Cougar XR7

1 Answer

Orange warning light on 156 sportswagon alfa...only bought car...the orange icon looks like a box with a cap??? 2002 sportswagon 2.4 diesel


That orange light icon that looks like a cap is the immobilizer sign and that means. Unfortunately this is common in these models and the best option is to get it diagnosed by a specialist before doing anything else or before the car stops on the road.

Dec 18, 2009 | 2000 Alfa Romeo 156

1 Answer

Replaced Fuel Tank now gas not getting to engine


You have a fuel cutoff/inertia switch in your vehicle. You may have to reset it. It will be grey or black....the grey one is cylindrical and the black one is square.

Jul 29, 2009 | 1986 Alfa Romeo Spider

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alfa Experts

old marine
old marine

Level 3 Expert

1992 Answers

David Harrelson
David Harrelson

Level 3 Expert

5316 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Are you an Alfa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...