Question about Cars & Trucks

Open Question

Out Side sencer who locks and location - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cam shaft position sensor 350z


The Cam Shaft Position is behind the motor on passenger side and has a green cap with 2 little wires going to it .with a 10 mm bolt to take out now what most people on here did not tell is that it was hard to take the green cap off the sencer first because the clip is on the bottom so you cant see it to take it off and if you just try to take a flat head screw driver to it you will bust your green clip.so take the sencer and cap off together and then take the green cap off after you get the sencer out .ok when you take the 10mm bolt out then you can reach down and pull the sencer out but its pretty hard just to pull out your going to want to twist it but you dont have to you are just pulling against the rubber O ring thats on the sencer just pull hard and it will come out.then pull the cap off .you acually push in on the clip towards the sencer to get it off ,not down ,but towards the bolt hole ,to take off,repalce clip put new sencer on and put sensor in motor,dont wiggle around on the wires to much because they are little and I could see braking one if not both

Mar 23, 2012 | 2004 Nissan 350Z

1 Answer

Transmisson sencer


The input an output speed sensors are located in the front of the transmission (the side facing the radiator). The input speed sensor is the one right below the rubber transmission cooler lines. the out put speed sensor looks exactly the same and is located more toward the drivers side of the transmission.

If you looking for a different sensor let me know. Thank you for using FixYa.com!

Feb 10, 2012 | 2005 Dodge Grand Caravan

1 Answer

Were is the map sencer located on a 1991 honda accord?


The map sensor is located on the passenger side fire wall

Dec 24, 2011 | 1991 Honda Accord

1 Answer

Need to replace power steering sencer


Not difficult to do. I had to do this for my 2002 neon. Go to your local parts store and buy a "power steering pressure switch"...should be around 20-25 dollars. It's located under the car near the driver side of the steering rack. All you need to do is unplug the wire, then use a 7/8" deep socket to remove the old switch. When installing the new one, use teflon thread seal tape on the threads and tighten snug but not too tight. Plug the wire back in and you're done. Afterwards, start the car and turn the wheel lock to lock a few times, then check for any leaking (the sensor itself can be seen from under the hood...look down behind the motor with a flashlight). Make sure the power steering fluid is at the correct level afterwards too. Good luck.

Apr 11, 2011 | 2002 Dodge Neon

2 Answers

89 grand prix do thay have an exturnal o2 sencer or is it in the brain box


The o2 sensor is in the exhaust. It is in the Y-pipe on the back side (firewall side) of the engine.

Dec 30, 2010 | 1989 Pontiac Grand Prix

2 Answers

Ware is the map sencer located


At the passenger side end of the upper intake. Between the coil pack and the alternator.

Nov 17, 2010 | 1998 Buick Park Avenue

1 Answer

Need to know were the bank 1 cam shaft sencer is located


For a V engine format it would be where cylinder #1 is and that should be the furthest front combustion chamber. Once located where it is, that would be Bank 1 on that cylinder head. Bank 2 will be the opposite cylinder hear. With the exception of the Bugatti W16 engine which will have 4 banks due to having 2 Audi V8 cylinder heads side by side (giving the engine a W configuration) and use 16 cylinders for combustion.

Jun 27, 2010 | 2004 Nissan Quest

1 Answer

Vw golf 1.4 2003 driver door sencer not working


Think it will be in the door lock - therefore if it's not working then you need a new lock.

May 08, 2010 | 2003 Volkswagen Golf

2 Answers

Where is 02 sencer heater (bank 1 sencer 2) located


I believe your car only has a single catalytic converter. If that's the case, then your bank 1 sensor 2 will be the O2 sensor that's located after the Catalytic converter away from the engine

Sep 15, 2009 | 2001 Oldsmobile Silhouette

1 Answer

Coolent temp sencer


Hello
Trace the upper hose back to the engine the sensor is located on the head thee here is a pic of it
RD
c613f3a.jpg

Jan 12, 2009 | 2004 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...