Question about Chevrolet Silverado
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: '96 Regal Purge Canister Valve?
THE PURGE SOLANOID IS ON THE ENGINE WITH A RED CONNECTOR ON IT. IT IS LOCATED ON THE REAR OF THE ENGINE ABOVE THE REAR VALVECOVER. YOU ARE ACTUALLY LOOKING FOR THE CANISTER VENT SOLANOID AND IT IS IN THE REAR OF THE CAR AND THEY FAIL OFTEN. GET THE PART FROM G.M. AND THEY CAN TELL YOU EXACTLY WHERE IT IS. THE G.M. PART IS UNDER $30.00.
Posted on Aug 26, 2008
SOURCE: purge solenoid location
which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. i'll answer both, lol
the locations are described as if you are looking at the engine from the front of the car with hood open.
on the blazer:
it is located on the left side of the intake manifold just under and behind the throttlebody. it is a canister looking device.
on the silverado:
it is located on the intake manifold on the left side in about the same spot as the blazer. providing the silverado has the 5.3 or 5.7 liter engine. if it also has the 4.3 then obviously it will be the same.
hope this helps!
Posted on Feb 17, 2009
You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Posted on Mar 19, 2009
There is a purge solenoid for the EVAP system and it is item no.# 1 shown in the diagram below. You have to follow the purge valve vacumn hose to find the charcoal cannister if you need to inspect.
I have included a description of the EVAP system for your understanding.
EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
The EVAP and on-board refueling vapor recovery (ORVR) system consists of a fill vent valve, fuel shut-off valve, fuel cut (roll-over) valve, fuel liquid/vapor separator, EVAP canister, EVAP canister purge solenoid valve, EVAP canister close valve, vacuum relief filler cap, and connecting lines and hoses. ORVR system is designed to prevent the release of fuel vapors during refueling. During refueling, as fuel enters the fuel tank, a vacuum is created in filler pipe, drawing air into the filler pipe and tank. Fuel vapor in fuel tank is then forced to the EVAP canister via the fill vent valve and the fuel liquid/vapor separator. A fuel tank pressure sensor is used for detecting EVAP system leaks by comparing pressures inside and outside of fuel tank.
EVAP Canister Purge Solenoid Valve
Fuel vapors are vented into the EVAP canister during refueling and when ignition is off. When engine is at normal operating temperature and engine speed is greater than idle, a thermovalve opens and allows vacuum to open the purge control valve. Canister vapors are then drawn into the intake manifold for burning during combustion. The purge control valve is kept closed during idle and engine warm-up to reduce HC and CO emissions.
Posted on Dec 16, 2010
The canister purge valve is located behind the intake manifold in the engine compartment on the firewall side .It should be a small round solenoid with a wire connector attached.It will have a feed hose from the evap cannister to the purge valve and then to the intake manifold.The evap canister is located on under the vehicle on the right side of the gas tank and is held in place by a bracket.If you follow these hoses it will also get you to the canister purge valve.I hope this helped.
Posted on Feb 03, 2011
Tips for a great answer:
Aug 01, 2016 | 2010 Chevrolet Impala
Mar 16, 2015 | 2013 Chevrolet Sonic
Aug 10, 2014 | 1996 Nissan Pickup
Aug 08, 2013 | Cars & Trucks
Apr 21, 2010 | 2000 GMC Jimmy
Mar 26, 2010 | 2001 Chevrolet Blazer
Feb 16, 2009 | 1999 Chevrolet Silverado 1500
Dec 02, 2008 | 2000 Chevrolet Silverado 1500
26 people viewed this question
Usually answered in minutes!