Question about Cars & Trucks

Open Question

802 2" Docooler tachometer. it has 5 wires coming out of it . two red two black one green ??where do they go

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Bat1956
  • 585 Answers

SOURCE: Install aftermarket tachometer

I'll take a stab at this, there's better than a 50-50 chance, and you can do no damage if the first try is wrong. Red is +12 volts and Black is chassis ground. that's a given. I would try Blue to coil pack "Tach" terminal, and Green for the dashlight. If I am right about the Blue and Green, a 9-volt battery from Green to Black will light the light if it's not burned out. If the Green doesn't light it, try the Blue, but my bets on the Green. If the Blue doesn't light it either, the bulb is toast.

Posted on May 08, 2009

  • 6982 Answers

SOURCE: How do I hook-up Sunpro Super tach 2.

I've got an install diagram for that around here somewhere but for now, the trigger wire to run the tach itself goes to the "tach" connection next to the "Bat" terminal on the distributor cap. one wire attaches to your dash lighting so it comes on with the dash lights and dims properly, the other wire is likely a ground. If I don't add to this later, try googling Sun electronics...I am fairly sure they have an install page.

Posted on Jan 04, 2010

  • 1 Answer

SOURCE: looking for assistance for the

blue and black can be tied together and chasis grounded. green goes to the distributer side of the coil. white to the dash lites or light switch fuse. the red must go to a on switched 12 vdc or switched b+.

Posted on Aug 19, 2011

emissionwiz
  • 75051 Answers

SOURCE: I have a YAZAKI tachometer unsure of which wires go where, black, yellow and blue, light no problem

You may have this posted in the wrong product category. Please select another category appropriate to the problem and re-post the problem so the correct expert will see and respond to the question..

Posted on Aug 31, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Specifically I'm trying to identify the wire on the spark plug coil assembly to which I should connect the signal wire of a Tachometer to. The wire colours are, red, yellow, green/white, and blue.


It says the tachometer wire is Yellow/Green, you do not have that listed. You will find it in the list below, it is highlighted..

WIRING INFORMATION 2001 Subaru Legacy






WIREWIRE COLOR LOCATION

12V CONSTANT WIRE WHITE Ignition Harness

12V IGNITION WIRE GREEN Ignition Harness

12V ACCESSORY WIRE YELLOW Ignition Harness

STARTER WIRE WHITE/BLACK Ignition Harness

POWER DOOR LOCK (-) WHITE Harness In Driver's Kick Panel

POWER DOOR UNLOCK (-) GREEN/RED Harness In Driver's Kick Panel

PARKING LIGHTS (+) ORANGE At Light Switch

DOOR TRIGGER (-) PINK/BLACK In White Connector Behind Fuse Box

TRUNK TRIGGER (-) YELLOW/BLUE In White Connector Behind Fuse Box

TRUNK RELEASE (5-wire) LT.GREEN/YELLOW At Motor In Tail Gate

FACTORY ALARM ARM (-) Factory remote only

FACTORY ALARM DISARM (-) Factory remote only

TACHOMETER YELLOW/GREEN At Ignition Coil

BRAKE WIRE (+) WHITE/BLACK At Brake Pedal Switch

HORN TRIGGER (-) RED/GREEN Harness At Steering Column

LEFT FRONT WINDOW UP BLUE/RED At Driver Window Motor Inside Door

LEFT FRONT WINDOW DOWN BLUE At Driver Window Motor Inside Door

RIGHT FRONT WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door

RIGHT FRONT WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

LEFT REAR WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door

LEFT REAR WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

RIGHT REAR WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door
RIGHT REAR WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

Feb 07, 2016 | 2001 Subaru Legacy

1 Answer

Where to connect green tacho wire on holden rodeo ra 2005 model


Assuming red is positive, black is negative or neutral the green is usually an earth wire and should be mounted to the cars frame.

Jul 08, 2013 | Cars & Trucks

1 Answer

How to wire the tachometer


Red goes to the ignition switch fuse for power in the fuse box green goes to the the negative side of the distributor white is for the tachs light so it will go to the dash light fuse in the fuse box and black is for the ground.

Oct 21, 2012 | 1993 Mercury Capri

1 Answer

How do you wire a tachometer in a 99 f-150 4.2


to wire a tacho red - positive
black - neg
green - negative of coil

Jun 18, 2012 | Cars & Trucks

1 Answer

Looking for assistance for the color code for a RAC Tachometer to hook up in my chevy truck, the colored wires are: black, blue, red, green and yellow.


blue and black can be tied together and chasis grounded. green goes to the distributer side of the coil. white to the dash lites or light switch fuse. the red must go to a on switched 12 vdc or switched b+.

May 11, 2011 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

Where can i get a wiring diagram for my 2002 chrysler neon auto


12V CONSTANT WIRE RED and PINK/BLACK Ignition harness
12V IGNITION WIRE DARK BLUE Ignition harness
12V ACCESSORY WIRE BLACK/ORANGE Ignition harness
STARTER WIRE YELLOW Ignition harness
PARKING LIGHTS (+) BLACK/YELLOW At Headlight switch
POWER DOOR LOCK (5-wire reverse polarity) ORANGE/PURPLE Harness Coming Into Vehicle From Driver's
Door
POWER DOOR UNLOCK (5-wire reverse
polarity)
PINK/PURPLE Harness Coming Into Vehicle From Driver's
Door
DOOR TRIGGER (-) YELLOW/BLACK At Headlight Switch
DOMELIGHT SUPERVISION (-) Use door trigger
TRUNK TRIGGER (-) GRAY/BLACK At Light In Trunk
TACHOMETER WIRE TAN/BLUE or BLACK/GRAY At Ignition Coil
BRAKE WIRE (+) WHITE/BROWN At Brake Pedal Switch
HORN TRIGGER (-) BLACK/RED Harness Coming From Steering Wheel At
Column
CAUTION! SRS airbag wires are not enclosed in protective loom at the steering column. They are a twisted pair of wires that run with rest of
ignition harness. Be careful not to cut or probe these wires.

Radio:

(Black plug)
Rear Right speaker -: Blue w/White stripe
Rear Left speaker -: Brown w/Yellow stripe
Front Right +: Purple
Front Left +: Dark Green
Rear Right speaker +: Blue w/Orange Stripe
Rear Left speaker +: Brown w/Blue Stripe
Power Antenna/Amp: White
(Gray Plug)
+12v battery wire: Pink or Pink w/White Stripe
+12v Ignition wire: Red w/ White Stripe
Front Right speaker -: Blue w/ Red Stripe
Front Left speaker -: Brown w/ Red Stripe

May 03, 2011 | 2002 Dodge Neon

1 Answer

Trying to hook a tachometer to a 93 gmc seirra 1500 350 were does the green wire go?


The "Green" wire from the tachometer should be attached to the negative side of the ignition coil only, and usually (but not always) it is a black wire with a white stripe or it is a solid white wire that will come off from the negative side of the ignition coil and often has a tab on the wire that says "Test" or "Tach" and the wire ends with an open black connector that is used for connecting a diagnostic device or tachometer for diagnostic purposes, and this is the wire that the green wire from the after-market tachometer should attach to. The "Red" wire should be attached to an "ignition" source connection on the fuse panel and have battery power when the key is in the "Run" position only, the "Yellow" or "White" wire should be connected to the "LPS" source on the fuse panel, and the "Black" wire should be connected to a good ground source and if the tachometer is not properly grounded then you will get a primary voltage shock from the ignition coil every time that you touch something metal inside of the vehicle. Let me know if you require any further assistance.

Oct 19, 2010 | GMC C1500 Cars & Trucks

1 Answer

What color is the power wire in 1994 toyota pick up


this might help
1994 Toyota Pickup Car Security Wiring Diagram
Battery Constant 12v+ Positive Wire (+): White And White/Red
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness
Starter Positive Wire (+): Black
Starter Positive Wire Location: Ignition Switch Harness
Ignition Positive Wire (+): Black/Yellow
Ignition Positive Wire Location: Ignition Switch Harness
Second Ignition Positive Wire (+): Black/Yellow Or Black/Red
Second Ignition Positive Wire Location: Ignition Switch Harness
Accessory Positive Wire (+): Blue/Red
Accessory Positive Wire Location: Ignition Switch Harness
Parking Light Negative Wire (-): Red/Black
Parking Light Negative Wire Location: At Steering Column Harness
Parking Light Positive Wire (+): Green
Parking Light Positive Wire Location: In Drivers Kick Panel
Power Door Lock Negative Wire (-): Blue/White
Power Door Lock Negative Wire Location: At Door Control Relay. The door control relay, is located behind the driver dash speaker.
Power Door Unlock Negative Wire (-): Blue/Yellow
Power Door Unlock Negative Wire Location: At Door Control Relay. The door control relay, is located behind the driver dash speaker.
Door Trigger Negative Wire (-): Black/White Or Black
Door Trigger Negative Wire Location: At 2-Pin Plug, Top Of Fusebox
Domelight Supervision Wire: Use Door Trigger, Requires Relay
Domelight Supervision Wire Location: N/A
Horn Negative Wire (-): Green/Red
Horn Negative Wire Location: At Steering Column Harness
Tachometer Wire Negative Wire (-): Black
Tachometer Wire Negative Wire Location: At Diagnostic Connector. The diagnostic connector, is located on the passenger inner fender near the fuse/relay box.
Brake Light Positive Wire (+): Green/White
Brake Light Positive Wire Location: At Switch Above Brake Pedal
Factory Alarm Disarm Wire (-): N/A
Factory Alarm Disarm Wire Location: N/A
Factory Anti-Theft System: N/A
Factory Anti-Theft System Location: N/A

Nov 29, 2009 | 1994 Toyota Pickup

2 Answers

Install aftermarket tachometer


I'll take a stab at this, there's better than a 50-50 chance, and you can do no damage if the first try is wrong. Red is +12 volts and Black is chassis ground. that's a given. I would try Blue to coil pack "Tach" terminal, and Green for the dashlight. If I am right about the Blue and Green, a 9-volt battery from Green to Black will light the light if it's not burned out. If the Green doesn't light it, try the Blue, but my bets on the Green. If the Blue doesn't light it either, the bulb is toast.

May 08, 2009 | Ford Bronco Cars & Trucks

1 Answer

2003 E350 tach pickup wire??


Tachometer Wire Negative Wire (-): Any Wire That Is Note Red/Light Green. The diesel tach wire is a green/white wire, located in a 5-pin harness held up with tape behind the parking brake release.
Tachometer Wire Negative Wire Location: At Igniton Coils

According to wiring diagrams online... good luck with this.
KEn

May 04, 2009 | Ford E-350 Super Duty Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...