Question about 1998 Plymouth Neon

1 Answer

Signal lights all work but when I turn on 4 way flashers only the front left works.What could be the problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Plymouth Master
  • 1,326 Answers

Faulty hazard switch or ground wire

Posted on Jun 10, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 160 Answers

SOURCE: 2 brake lights, turn signals not working 1999 plym. grand voyager

relay

Posted on Nov 11, 2008

  • 88 Answers

SOURCE: left turn signal doesn't work but the right one does

signal switch assembly. you have to buy the arm from the dealer only. the switch is bad inside the arm.

Posted on Dec 23, 2008

wracefans24
  • 1985 Answers

SOURCE: No signal lights at all and no emergency flashers

you need to check the "combination turn signal/hazard flasher/daytime running lights module"
it is located in the junction block,the junction block is adjacent to and left of the steering column,you need to remove the lower dash panel below the steering column,then remove the steel knee brace.

Posted on Jan 01, 2010

  • 4 Answers

SOURCE: Right Turn Signal not flashing.

quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Posted on Apr 19, 2010

jturcotte
  • 8190 Answers

SOURCE: My turn signals work very inconsistently. I have

Replace the Park relay--probably in the engine compartment relay box. If that doesn't fix the running lights, you can get a new headlight switch for $100. That should fix the running lights.
The turn switch is $120, but I don't think it's too hard to replace. Or, you may be able to repair it--I would try. Take it off and look in back at the contact that should be made when the wand is pulled down. It is probably burned up and maybe melted a bit, but you may be able to fix it up enough to work another 50K miles...

Let us know if you have questions.

Posted on Oct 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I repair a malfunctioning left front signal light?


The flasher unit for the four ways is separate from the turn signal.
If the rear light is flashing fast means the front light is malfunctioning. Check all wiring from the dash to the light itself. I had one a wire was pinched and had broken

Jul 19, 2015 | Cars & Trucks

1 Answer

Right blinker not working 1999 Buick park avenue


You'll need to find a wiring diagram an component location chart to check this out . Here is a diagnostic flow chart for trouble shooting this problem ! Do you know how to use a voltmeter ?
DEFINITION: This table diagnoses inoperative turn signals on one side. It assumes that the cornering lamps, hazard lamps, and turn signals on the other side all operate properly.

1

Did you perform the Exterior Lights System Check?
--
Go to Step 2 - yes
Go to Exterior Lights System Check - no

2

  1. Disconnect the turn signal flasher connector.
  2. Turn the ignition switch to the RUN position.
  3. Place the turn signal switch in the appropriate position.
  4. Connect a DMM from the appropriate turn signal flasher connector cavity to ground:
?€¢
LH: cavity C (ORN)


?€¢
RH: cavity B (BLK)

Is the voltage within the specified range?
10-15 V
Go to Step 3 yes
Go to Step 5 no

3

Connect a fused jumper between the appropriate turn signal flasher connector cavities:
?€¢
LH: cavity C (ORN) to cavity D (YEL)


?€¢
RH: cavity B (BLK) to cavity F (TAN)

Do the appropriate turn lamps light without flashing?
--
Go to Step 4 yes
Go to Step 6 no

4

Replace the turn signal flasher. Refer to Hazard and Turn Signal Flasher Replacement .
Is the repair complete?
--
Go to Exterior Lights System Check
--

5

Repair the open in the appropriate circuit:
?€¢
LH: CKT 57 (ORN) between S200 and the turn signal flasher


?€¢
RH: CKT 58 (BLK) between S201 and the turn signal flasher

Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
--
Go to Exterior Lights System Check
--

6

Repair the open in the appropriate circuit between the turn signal flasher and the IP fuse block:
?€¢
LH: CKT 685 (YEL)


?€¢
RH: CKT 686 (TAN)

Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
--
Go to Exterior Lights System Check

May 09, 2015 | 1999 Buick Park Avenue Ultra

2 Answers

Flasher relay location Pontiac Bonneville 2004 removal and installation.


If the right side works it's not your flasher, Its your left side bulb, either front turn signal or rear tail light bulb.

Aug 02, 2014 | 2004 Pontiac Bonneville

1 Answer

88 Jeep Cherokee, left turn signals don't work. Right signals flash as they should. Emergency flashers work as well. When the left turn signal is activated, the dash arrow lights up, the front bulb lights...


Quite a puzzle you have that seems impossible, though such things weren't unusual in the old days of bimetal flasher units. The modern electronic flasher relay is designed to flash at a speed dependent on the amount of current drawn by the circuit so if a bulb goes out the speed doubles or thereabouts, giving the driver an indication something is wrong.
Broadly speaking the flasher unit will operate as it is designed within a current range so if there is too much current flowing or not enough it probably won't work at all.

The turn signal switch is usually a very reliable thing and as the left hand lamps light it is fair to assume it is working ok. If the switch is accessible it would be simple to measure the current being consumed by the circuit, which would be nearly 4 amps with the engine running at a fast idle. If it isn't then I suggest you revisit the lamp grounds and other connections.

My instinct is to suspect the hazard warning switch. It is often an unnecessarily complex switch and wiring arrangement and often responsible for turn signal malfunctions. Mostly operating the switch rapidly for a few minutes puts matters right, though if it doesn't I suggest you check the multiway connector behind the switch.

May 28, 2017 | 1988 Jeep Cherokee

1 Answer

No left turn single


assuming you have check both front and rear signal lights and they are working then it sounds like the signal flasher is not working for the left side only.put on the hazard flashers to check bulb operation and if the bulbs work then the only thing in the system is the turn signal flasher not working for the left side.the signal flasher looks the same as the hazards but is a different flasher located in the same area as the hazard.

Jun 29, 2011 | 1997 Ford F350 Crew Cab

1 Answer

Left turn signal works / don't work, brake light


possibly flasher unit faulty
or turn signal switch

Feb 22, 2010 | 2000 Jeep Grand Cherokee

1 Answer

1987 toyota camry s/w back left (driver's side) turn signal does not work, bulb and ground are good, front left signal works but flashes fast, rt side signal both working ok. when emg flasher is turned...


Problem solved, Since 3 of the 4 turn signals worked I did not fuse was a problem
but after checking the turn swithch, I pulleded out the fuse which looked ok, but when
I put it back in all the turn signal lights woked! Apparently just one part of the surface
of the fuse was corroded.

Aug 01, 2008 | Toyota Camry Cars & Trucks

Not finding what you are looking for?
1998 Plymouth Neon Logo

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...