Question about Cars & Trucks

1 Answer

Sometimes it misfire when start and shake - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

  • Cars & Trucks Expert
  • 126 Answers

Change your spark plugs and wires along with the cap and rotor depending on if you have one or not.

Posted on May 02, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a 99 ford f150. Sometimes it runs perfect, then out of no where when I try to accelerate it vibrates bad and becomea hesitant. When I came to a stop I switched threw all gears and it seems like it...


This sounds like you might have a bad plug wire or something else in the ignition system is arcing to ground. A quick way to verify this is to run the truck in Park at idle. Next, spray the ignition wires with Windex. You'll notice the truck starting to rough up and might even see the bad wire arcing to ground. A complete tuneup would be recommended in this case.
I hope this helps! :)

Jun 11, 2014 | Cars & Trucks

1 Answer

My 1997 Ford Explorer XL shakes when I start it. What could it be?


Spraying WD40 on the belt stops it from squeaking, no need to replace it.
If it is misfiring, that will cause a shudder at low RPM.
There is no such think as an intake valve gasket. A manifold gasket on the inlet side, can let air into the mixture and cause misfire. Normally that is fixed by tightening loose nuts on the studs that locate the manifold.

Aug 07, 2017 | 1997 Ford Explorer AWD

1 Answer

2004 land rover discovery bosh engine shakes whole vehicle when start up for a while then goes away. sometimes shakes while driving. sometimes while coasting, sometimes when idling in park and sometim


have the lifters removed and check for leak down and blocked oil holes and worn plates, broken springs. have the injectors checked for blocked tips . Have the fuel manifold pressure tested to ensure adequate fuel pressure is maintained as that also causes misfiring.

Mar 02, 2014 | Land Rover Cars & Trucks

1 Answer

1992 toyota camry shaking very bad could this be a blown head gasket.. the machanic says its the first spark plug


Hi,

When a cylinder is misfiring, this dirupts the balance of the engine and the computer is sometimes unable to compensate during a misfire.

This also, can often cause erratic engine behaviour...and shaking like a tank.

It may simply be a bad spark plug, HT lead, or something more serious.

Have the onboard diagnostics checked first - this will indicate which (if any) electrical component is at fault.

This can be done by a local Toyota dealership, with the correct scanning equipment.

Nov 12, 2009 | 1992 Toyota Camry V6

1 Answer

Shaking at low speed (25-30 mph)


low speed shakes indicates a wheel alignment problem
have the suspension and wheel bearings checked out by an accredited suspension shop
under acceleration it could be engine mounts cracked in the rubber being actuated by misfiring form a cylinder
run the fault codes as well

Aug 31, 2017 | 2003 Honda Odyssey

2 Answers

Car Shakes When Driving


I had the shaking problem too, had the #5 coil replaced and the shaking instantly stopped.

Apr 15, 2009 | 2000 Nissan Maxima

2 Answers

I have a 1996 oldsmobile cutlass supreme sl 3.4l and sometimes my car will shake a little and the check engine light will come on and sometimes i will be driveing and when i hit the gas and take off fast...


the flashing check engine light is indicating a misfire. if you can't get it scanned for codes, start with the obvious, check plugs, wires, and coil packs first.

Feb 21, 2009 | 1996 Oldsmobile Cutlass Supreme Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...