Question about 1997 Mitsubishi Mirage

1 Answer

How do I bleed my clutch on my Mitsubishi mirage 1997 model I'm on the side of the road

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 3,957 Answers

Not really a side-of-the-road procedure:
http://www.dsmtuners.com/threads/how-to-properly-bleed-your-hydraulic-clutch.213503/

Posted on Apr 29, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Danniboi
  • 1098 Answers

SOURCE: looking for a manual. 1997 Mitsubishi Mirage

Hi I found these, scroll down to the bottom of the page

Hope this helps, please click the link

Regards
Dan
http://shop.ebay.co.uk/?_from=R40&_trksid=p3984.m38.l1313&_nkw=1997+Mitsubishi+Mirage+manual&_sacat=See-All-Categories

Posted on Feb 14, 2010

  • 29 Answers

SOURCE: my clutch in my 95' mitsubishi mirage is sticking

could be the fluid. if the clutch was worn out it would be doing the opposite of sticking. is the clutch pedal easier to push than normally?

Posted on Dec 04, 2010

wencal1963
  • 153 Answers

SOURCE: HOW TO ADJUST HEADLIGHTS IN

There are torex screws on under the hood above headlights you can use a 6mm / 12 point socket or wrench also

Posted on Jan 04, 2011

  • 368 Answers

SOURCE: fuel gauge reading half with full tank on 1997

It is a fuel gauge sensor also known as the level sensor, There is a level sensor that has a boot spring attached to it that is probraly jammed, or just simply damaged. This will need to be replaced, you can located this at your fuel pump, which in normal case is underneath you rear seat in which side is your fuel door is located. Once you located the opening of the fuel pump passage then there is normally 6-8 small bolt that is screwed to hold your fuel pump to the fuel tank and some cable harness. Theses will need to be taken off in order for you to take your fuel pump. In my best advice, you minus well replace your whole fuel pump system to save time and complication when installing

Posted on Jan 21, 2011

  • 2 Answers

SOURCE: where is the fuel pump location on a 1997

The fuel pump is located in the fuel tank. You MUST drop the tank to see and replace it.

Posted on Nov 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Firing order for 97 Mitsubishi, mirage


The firing order would depend on which specific model and engine you have in your mirage. A complete list with diagrams can be found here:

http://www.autozone.com/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c15280037cb8

Feb 25, 2015 | 1997 Mitsubishi Mirage

1 Answer

How to bleed my mirage clutch


please visit link below for mitsubishi forums

Aug 25, 2014 | Mitsubishi Mirage Cars & Trucks

1 Answer

Where is my fuel filter on my 95 mitsubishi mirage coupe


look under the car along the driver side, could be under a little cover follow the gas lines

Jan 09, 2011 | 1997 Mitsubishi Mirage

1 Answer

Becoming increasingly difficult to select all gears,as if clutch not fully dis-engaging although clutch is working properly


Check to make sure there is not air in the hydraulic system this will cause the slave cylinder to only partially operate thus causing difficulty in shifting gears also check the condition of the slave cylinder itself. Be sure its not leaking. Last but not least the synchronizer in the tranny may be bad cusing the problem.If there is are in the hydraulic system try bleeding the system.

Dec 23, 2010 | 1997 Mitsubishi Mirage

1 Answer

My clutch in my 95' mitsubishi mirage is sticking suddenly. do i need a new clutch or could it be my fluid?


could be the fluid. if the clutch was worn out it would be doing the opposite of sticking. is the clutch pedal easier to push than normally?

Dec 04, 2010 | 1995 Mitsubishi Mirage

1 Answer

Clutch will not engage, when you force it , you can hear it spinning or whatever. when you turn off engine it shifts great. please advise how to adjust clutch petal, it is low or soft, EMERGENCY PLEASE


Replace your Clutch, Hydraulic Clutch System can't be Adjusted but check if oil level is good if not add the missing oil ( With DOT-3 Brake Oil ) try by bleeding it if nothing changed, your clutch need's to be Replaced !

Aug 10, 2010 | 1997 Mitsubishi Mirage

1 Answer

Where i can find the vin number on the engine block of a mirage 1997 ,1.5


go to out side vechlcle on driver side look through windshield its the long number on dash.your vin number is also on vechicle registration.

May 08, 2009 | 1997 Mitsubishi Mirage

Not finding what you are looking for?
1997 Mitsubishi Mirage Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...