Question about 1991 Nissan 300ZX

Open Question

Why would my lock on my 1991 nisson 300zx not lock the doors

I can lock the passenger side door but not the driver side

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 42 Answers

SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel

This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal

Posted on Mar 20, 2009

Ad
memturbo
  • 226 Answers

SOURCE: 1991 Nissan 300ZX fuse box diagram needed

first here is the service manual http://www.300zx-twinturbo.com/cgi-bin/manual.cgi

next is the kick panel http://209.85.62.26/12640/0/upload/p979648.jpg

These should be right or very close .

Posted on Mar 27, 2009

mcgyver468
  • 710 Answers

SOURCE: Passenger side door will not open from inside or outside.

linkage on inside of door has come undone. take off inside door panel and you will find a small rod that goes to the lock mechanism where the door closes opposite the hinges. follow the handle to the door lock.the nylon bushing may have broken.they are cheap to purchase at auto part stores.

Posted on Apr 21, 2009

TwinTurboZ
  • 78 Answers

SOURCE: 1993 nissan 300zx door panel removal to fix lock

Its tricky but you need to pop the half circle off to get to the 14mm bolt. Then roll the window down and there is a plastic circle at the top of the door frame. Pop that off and remove the one plillips screw and pop the panel off to get to the remaining 2 10mm bolts holding the door panel on.

Posted on May 23, 2009

  • 86 Answers

SOURCE: Nissan Murano (05) Power Locks Sticking

The door lock actuator in that door is weak. Need to replace it.

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door locks unlocks


Sounds like the main wiring loom into the door has been damaged.
Check near the hinges, where the door swings, to see if any damaged wires. Does the door lock and unlock from the drivers side switch?

Jan 04, 2014 | Toyota Cars & Trucks

Tip

Double lock doors


You can “double lock” your doors by turning your key all the way to the right from the drivers side door and all the way left from the passenger side door.

on May 19, 2008 | 1991 BMW 3 Series

1 Answer

I went to unlock the driver side door of my 91 acura legend and i guess i set factory alarm off.i do not have original key and my car wont start.. help p[lease!!!!!


The alarm must of activated , the alarm is controlled by the locks, go to passenger door and use the key to lock and then unlock the door, this will shut down alarm, you may have to use the passenger door to shut down alarm due to a bad switch in drivers door, this will allow you to start the car, you can also not lock door and alarm may not arm. let me know if the passenger door lock works, good day.

May 24, 2012 | 1991 Acura Legend

1 Answer

1986 nissan 300zx passenger door wont open from inside ,can from outside


Remove the inside door handle cover , Take out the piece that has yhe rods attached to it . There is 2 black plastic pieces that one opens the door and the other one locks the door. One is broken . The one that opens the door from inside, Reolace the piece and put the rods back on. put cover on . Done.

May 07, 2012 | 1986 Nissan 300ZX

1 Answer

Power locks don't work with remote or control from


The door lock/unlock input from the driver's key switch goes to the Door Multiplex control unit (main switch), the Door multiplex control unit then sends a signal on the BUS (CAN) circuit to the passenger's multiplex control unit; the passenger's multiplex control unit then controls all the door locks. The passenger's door lock key switch inputs to the passenger's multiplex control unit, if the locks work from the passenger's side key switch but not the driver's side key switch, the most likely cause is the driver's multiplex control unit (main switch) not sending the signal to the passenger's side multiplex control unit. This could also be the drivers side door lock actuator. Hope this helps!

Jan 07, 2010 | 2003 Honda Pilot

1 Answer

Driver side door stuck shut..willnot open


Take it to the Honda dealer, they will fix it for free, known problem and under factory warrenty.

Mar 08, 2009 | 1991 Honda Accord

1 Answer

Door actuator 1991 bronco( passenger side)


you need to  take off the inside panel. if i remember correctly its just a couple screws and it should pop off.

Jun 08, 2008 | 1991 Ford Bronco

Not finding what you are looking for?
1991 Nissan 300ZX Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...