Question about Buick Cars & Trucks
If the car doesn't get hot enough to start the fans they wont come on, if your fans are indeed good and you checked them with a trouble shooting cable, then I would suspect the thermo switch for them.
Posted on Apr 28, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
there is no easy way to change out a heater core...you have to take the bottom part of the dash loose and that takes some doing. once you get the bottom of the dash apart you will see the heater core.then you have to go under the hood and unhook both water lines that run to it, you should then be able to pull the heater core out and install the new one
Posted on Feb 09, 2009
Remove or Disconnect
Door handle trim plate.
Remove or Disconnect
Posted on Mar 14, 2009
BCM --The Body Control Module is located on the right side of the vehicle and positioned under the instrument panel. In order to gain access to the module, it will be necessary to first remove the trim panel.
Posted on Jun 23, 2009
Firt - study & write down (draw) the belt path,,
and be sure about it..
Then - put a wrench on the nut in the center of the tension pully.. Move the tension pully to loosen the belt.. Pull belt off..
Repeat to put new one on..
Should be pretty easy..
Posted on Jul 09, 2009
SOUND LIKE DEAD BATTERY.CHECK BATTERY CABLES MAKE SURE THEY ARE TIGHT FREE FROM CORROSION.CHECK BATTERY VOLTAGE IT SHOULD BE 12.5 VOLTS.IF NOT CHARGE OR REPLACE BATTERY.MAKE SURE ALTERNATOR CHARGING BATTERY.WITH ENGINE RUNNING USING A DIGITAL VOLTMETER HOOK TO CAR BATTERY YOUR VOLTAGE OUT PUT SHOULD BE 13.5 TO 14.5 VOLTS.IF NOT CHECK ALTERNATOR FUSE AND ALTERNATOR WIRES MAKE SURE NONE OF THEM NOT LOOSE OR BROKEN.MAKE SURE DRIVE BELT NOT LOOSE.TURN OFF RADIO BEFORE REMOVING THE NEGATIVE BATTERY CABLE.IF BATTERY AND ALTERNATOR GOOD CHECK THE IGNITION SWITCH FUSE.IF SWITCH FUSE IS GOOD.IGNITION SWITCH IS OPEN NEED REPLACING.DISARM AIRBAG IN STEERING WHEEL FIRST BEFORE REMOVING IGNITION SWITCH.REMOVE BATTERY NEGATIVE CABLE WAIT 20 MINUTES TO ALLOW AIRBAG TO DISCHARGE BEFORE REMOVING THE IGNITION SWITCH.
Posted on Jun 22, 2010
Tips for a great answer:
Sep 30, 2013 | 2002 Buick Park Avenue
Aug 05, 2012 | 1990 Buick Electra
May 29, 2012 | Buick Park Avenue Cars & Trucks
Aug 01, 2010 | 1991 Buick Park Avenue
Jun 27, 2010 | Cars & Trucks
May 17, 2010 | 1998 Buick Park Avenue
Feb 10, 2010 | Buick Park Avenue Cars & Trucks
Dec 24, 2008 | 1997 Buick Park Avenue
29 people viewed this question
Usually answered in minutes!