Question about 2003 Dodge Durango

1 Answer

2003 dodge durango while driving lost acceleration, shut it off, restarted then drove fine for about 4 miles did the same thing but this time it didn't want to start. After a couple minutes it started

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 286 Answers

Sounds like the crankshaft sensor gets warm and then opens up, once cooled off it closes again ( it is a transformer in epoxy housing ) I would replace it.

Posted on Apr 28, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2000 Dodge durango wont start after driving for a while.

i had the same problem in a dodge ram pick up. ended up being the coil. when the coil got hot my truck would die or not start again until the engine had cooled down. replaced the coil, and whalaaaaah. no more trouble. good luck!!!!!!!!!!!!!!

Posted on May 12, 2009

  • 6982 Answers

SOURCE: engine dies, starts rough

Most large parts stores read codes free. Most common cause is crank sensor, but I'd have code checked before buying anything.

Posted on May 27, 2009

greg_margo
  • 1959 Answers

SOURCE: Dies after running about 2 minutes

It's got all the symptoms of a leak in the fuel line. You may want to start backward at the tank and work your way all the way to the carb to find it but it would be surprising if it was something else. All the best.
Greg

Posted on Jun 15, 2009

  • 5 Answers

SOURCE: 1987 pontiac fiero starting problem

the ignition control module goes bad as well. when it goes bad, things like this happen too often in these cars. my car had the same problem. and it didnt work right til i changed the ignition control module which is inside the pick up coil

Posted on Jan 01, 2010

baileybre268
  • 1 Answer

SOURCE: 2000Nissan Frontier, 4 cyl, 2 whl drive, auto,

have 2000 frontier 70000 miles driving down highway everything just fine then engine stalled and never started found out the tensioner for the timing chain stuck causing engine to jump timing check top tensioner that keeps your chain tight

Posted on Dec 16, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 dodge durango 5.7l with the hemi, won't start


I would start by checking the basics which are checking for spark and fuel. If you have a gauge, check to see if you have fuel pressure when the key is turned on. If you have fuel pressure, check for spark. Chrysler products are known for the crank shaft sensor to go bad and cause a no start. Also, if driving for a certain period with the pedal depressed at the same speed, the throttle position sensor will stay at that position if stuck and will cause either and driveability problem or stalling. You may wanna look into replacing or at least checking that. Good luck.

Feb 04, 2013 | 2004 Dodge Durango

1 Answer

While driving my 2006 Dodge Durango, the malfunction indicator light was on and the engine cut out while I was driving - no exterior lights or power steering, but interior lights and radio were still on. ...


dodge durango cuts off when starting however , when I press on the gas it will stay started whats the issue ? Just had oil & change all fluids checked in may 2014 for a dodge durango . plan on taking a drive from seattle wa to California San Diego is it safe to do so ?

Jun 13, 2011 | 2006 Dodge Durango

1 Answer

I have 2003 Dodge Durango and when I accelerate above 40mph there is a vibration. When I remove foot from gas the vibration stops. Can coast at speeds with no vibration.


How many miles on your Durango? This could be a failing U joint on either driveshaft. Could also be a ties out of balance or going bad.

Since the vibration goes away when coasting, I am voting for a driveline issue.

Apr 20, 2010 | 2003 Dodge Durango

2 Answers

Stalls / Dies / dead


this engine fuel pump prassurae low. it fuel pump celan. Your problem sovel

Jul 13, 2008 | 2003 Ford E150

1 Answer

Electrical


after another check,determined it was bad alternator

Jul 08, 2008 | 1998 Ford Windstar

Not finding what you are looking for?
2003 Dodge Durango Logo

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...