Question about Cars & Trucks

1 Answer

Been on holiday...Satbox is saying "no signal"

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Cars & Trucks Master
  • 1,585 Answers

Unplug for 15mins

Posted on Apr 27, 2015

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Which is the best website relating to Holiday faroe islands?

There are a number of websites on the internet which are offering information relating to Holiday faroe islands. These are specially made for all those Men and women that are looking for quality advice relating to Holiday faroe islands. To Learn More please see this site:

Aug 24, 2017 | Cars & Trucks

2 Answers

Can someone suggest an affordable Kerala holiday package which gives full value for money?

Go ahead and search online at sites like You will surely find one of the best and affordable Kerala holiday package.

Feb 09, 2013 | Cars & Trucks

1 Answer

My head lights just went off and on several times. It did it again tonight.

The lighting control module is the likely culprit. It's located under the dash just to the left of the ashtray on the driver's side. 3-7mm screws and two plastic tabs hold it in (two plugs). It controls the headlights (which are also independently fused #23 & 24), turn signals, interior dome light... Have the turn signals been flashing erratically or the dome light not dimming or coming on? They are also signs of a bad module. I hope I've helped. If so please rate my assistance. Thank you and Happy Holidays.

Dec 19, 2010 | 2005 Mercury Grand Marquis

1 Answer

Rear right signal bulb How do I get at it to change it?

Open the hatch. Pull out the two nickel sized plastic locks, slide the assembly out, untwist the socket. If I've helped, please rate my assistance and leave a comment to help others in a similar situation. Thank you and Happy Holidays.

Dec 16, 2010 | 2006 Dodge Caravan

1 Answer

What are the ohms readings for the map sensor between full vacuum, and no vacuum?

this is tested hooked up and looking for specific voltage as follows:
4.4v at100 kpa
3.2v at 80 kpa
2.1v at 60 kpa
1.1v at 40 kpa
0.5v at 20 kpa
the terminal has 3 wires a,b,c, a is ground, b carries the output signal to the ecu, and c is the 5v reference signal. while engine not running it register with about 5v.
happy holidays

Dec 29, 2009 | 1991 Volvo 940

1 Answer

Turn on right signal light both right and left light blinking

Hi and welcome to FixYa,

Initially, would appear that there is a loose ground on the signal light wiring. One way to verify is to temporarily jump with a short length of electrical wire the ground (body) of the bulb/socket to any exposed metal part of the vehicle and try again.

Good luck and Thank you for using FixYa. Happy Holidays.

Dec 11, 2008 | 1997 Dodge Caravan

1 Answer

1999 Chevrolet Silverado 4x4

Hello Ron,
There are a few things you can try, first of all take a look under the drivers side brake lights you will see a bunch of wiring there going into a block sometimes the wires will just fall out after a few years of getting hot,cold ect. Now make sure that all the wires are plugged in and tight. Now if thats all ok the next thing you can try is to take off the negative post on your battery and leave off for about 10 minutes should be enough to reset computer. Now after you do that you may have to reset the security system, Now what you want to do is make sure battery is hooked back up, and now you want to make sure your window is down drivers side in case doors lock, Unless you have another set of keys, Now use the key with the little sensor on it put it in ignition and turn key to the on position and leave on for 15 to 20 minutes remember not running the engine just in the On position, After that time go ahead and try everything out, Everything should be set back to the factory setting on your computer and security center. Alright Ron Thats about it for now. Give me a hoot if you need to ask me anything else. OK And Thanks for Using Fix Ya Bear001

Jul 07, 2008 | 1999 Chevrolet Silverado 1500

2 Answers

Signal light quit working

Check the bulbs. The flasher won't even go if the bulbs are burnt out!

Jul 01, 2008 | 1991 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides