Question about Seat Cars & Trucks

1 Answer

I have a 2008 HHR the power seat won't go forward

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Seat Master
  • 12,440 Answers

Did you check under the seat for obstructions in the seat track ? Check for battery voltage at the control switch an at the motor under the seat !

Posted on Apr 27, 2015

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
subytech1
  • 244 Answers

SOURCE: drivers seat 2000 outback

So here is a diagram of the seat circuitry for your car. Since every other function works except the forward/backward slide function, that leaves basically the forward/backward slide motor, the seat switch, and/or the wiring. If you can verify that the wiring under the seat is in good condition without obstructions, chaffed wires, and/or wires pulled too tight, then it's safe to say it's down to just the motor and/or the switch. Sometimes if the passengers front seat has the same switch, you can plug it in to the drivers' side connector and see what works and what doesn't. If the seat works fine with the other switch, then that's all it needs, if not then it will need a motor. If the other seat doesn't have a switch then you can find them at wrecking yards, or just supply power and ground to the motor in question to see if it works. If it does, then you know you kneed a switch and if not then a motor.
I hope this info helps!~subyguru~
82066173

Posted on Jan 19, 2012

  • 104 Answers

SOURCE: how do you remove the passenger seat belt from a 2008 chevy hhr

This is extensive steps to do this which you will need the actual diagrams from the manufacture. We can give them on our site as we pay them to allow us to distrubute them so there is no copyright issues come by and get the info plus help from a Mechanic

http://www.expertcaradvice.com/askquestion.php

Posted on Jan 22, 2012

  • 457 Answers

SOURCE: 2006 KIA Optima EX Passenger Power Seat won't adjust back

seat motor is no good and needs replaced if switch is working in each position

Posted on Jul 29, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ambient temperature sensor located ?


images for 2008 Chevrolet HHR LT Where is the .

Outside Temperature Sensor - Chevy HHR Network

www.chevyhhr.net/forums/...hhr-4/outside-temperature-sensor-30594/
Jul 9, 2010 - I had the outside temp sensor go on my 99 Buick. I don't know where it islocated on the HHR, but it was just a plug in sensor. Take out the old, stick in the new.... 2008 HHR LS 2.2 L Auto Built: 12-19-2007. Bought: 4-26-2009 Location of the ambient engine temperature sensor.... Help ...
Mar 26, 2013
Engine Temperature Sensor
Oct 6, 2011
Outside Temp Display
Dec 19, 2008
Outside air temperature problem
Oct 30, 2007
More results from www.chevyhhr.net

Jan 25, 2016 | 2008 Chevrolet Chevrolet HHR LT

1 Answer

How to remove back seat of hhr 2006


Rear Seat Replacement

showgif.do?image=1592810

tif.gif

Callout

Component Name
Notice: Refer to Fastener Notice in the Preface section.
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Preliminary Procedure Remove the rear compartment floor stowage compartment tray. Refer to Rear Floor Trim Plate Replacement .
1
Nut, Rear Seat (Qty: 6)
Tip
Roll the seat forward enough to get access to the nut that attaches the center seat belt assembly to the floor.
Tighten
45 N?·m (33 lb ft)
2
Bolt, Rear Seat (Qty: 3)
Tip

  1. Adjust the seat forward or rearward to access the bolts.
  2. Remove the plastic trim pieces to gain access to the nuts.
Tighten
45 N?·m (33 lb ft)
3
Rear Seat Assembly

Oct 28, 2015 | Seat Cars & Trucks

2 Answers

2008 ford fusion seat motor wont go forward


Check out for a fuse or relay switch.

Jan 03, 2015 | 2008 Ford Fusion

1 Answer

Driver seat won t move up or down


Horizontal Switch on side

Mar 16, 2014 | 2008 Audi A4 2.0

1 Answer

The power and heat doesn't work on the driver seat in my 2006 chevy hhr


You may have a bad switch or some electrical problem with that.
Check to see if you have a separate fuse just for the driver seat on your fuse box by looking at the diagram on the fuse box cover.
I think it there is a fuse it would control both sides.
Take it in to an auto electric place, they would be able to solve your problem quickly.

Nov 06, 2013 | 2006 Chevrolet HHR

1 Answer

How do you reset the relay switch for seat on the driver side of 2006 chevy hhr


There is no 'reset'. There are fuses you can check. See your owner's manual to read through the fuse listing. Also be sure your wiring didn't become unplugged under your seat, as if something was lodged under the seat pulling on the wiring.

Nov 06, 2013 | 2006 Chevrolet HHR

1 Answer

How do you remove the passenger seat belt from a 2008 chevy hhr


This is extensive steps to do this which you will need the actual diagrams from the manufacture. We can give them on our site as we pay them to allow us to distrubute them so there is no copyright issues come by and get the info plus help from a Mechanic

http://www.expertcaradvice.com/askquestion.php

Jan 22, 2012 | 2009 Chevrolet HHR

2 Answers

Cant locate the fuse for the cigarette lighter in my hhr 2008


The cigarette lighter fuse is located in engine compartment under hood. Engine Compartment Fuse Block: The under-hood fuse block is located on the driver side of the engine compartment. Lift the cover to access the fuse/relay block.Fuse number 29 is cig lighter fuse. ---------------------- If you want complete manual for your vehicle,please click on the link below:---- http://www.chevrolet.com/assets/pdf/owners/manuals/2008/2008_chevrolet_hhr_lt_owners.pdf The fuse box diagram is located on page number 5-121 and 5-122. --------------------- Thank you.

Jan 31, 2011 | 2008 Chevrolet Hhr

1 Answer

Change drivers headlight on 2006 hhr


remove the forward portion of the left front of the wheel house liner, ( the plastic peice inside the fender behind the drivers wheel ). disconnect the electrical connector and turn the headlamp holder 1/4 turn counter clockwise and remove . reverse procedure to replace.

Dec 26, 2009 | 2008 Chevrolet Hhr

1 Answer

I own a chevy hhr 2008,this morning im getting


please make sure the vehicle is fully in park, turn the key forward to on and try removing it, while depressing the brake pedal

Jul 18, 2009 | 2008 Chevrolet Hhr

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Seat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Adam Truesdale

Level 2 Expert

293 Answers

Are you a Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...